forum.pistar.uk

Hello, Here is the scenario.. I have a pistar dmr repeater. TS 1 = TGIF TS2 = Brandmeister DMR Master = DMRGateway I try to check into a net on TG 31012 (quadnet ). Ncs acknowledged me. When it was my turn to I make a transmission, my audio drops after a few seconds. Radio is a vertex VXD-7200 ( lik...

Hello all! I enabled FM mode which seemed to work just fine. Now the transmitter keys up intermittently. The intermittent issue goes away when i disable FM mode. Squelch setting is normal. I only have 2 settings in CPS, normal or tight. what setting in FM mode should i be looking at to see if the pr...

I put together a Pi_STAR DMR repeater using 2 Motorola CM200's. I'm not interested in enabling the other modes, so it will be DMR only. I programmed both transmitter and receiver bandwidth at 12.5KHZ which i figured DMR is narrowband. I had other ham operators tell me i had to configure both radios ...

Another issue popped up. My repeater was configured to have TGIF on slot 1 and Brandmeister on slot 2. DMR Master was set to DMR Gateway. everything was working well until I enabled FM Mode. Now DMR NET goes offline after a few seconds. Both networks have security password protection enabled. If i c...

Was able to get the FM option to work only after upgrading the firmware of the ST32DVM board.

Now to figure out what all the settings mean and what they do lol!
tnx
mike w8vpc

TNX for the reply. The ST32DVM board is connected to two Motorola CM200's running full duplex mode. So FM mode should work. Repeater identifies every 10 minutes. I'm also using a cable assembly made by the same company that makes the ST32DVM board. I will email them and see if they have any suggesti...

I put together another repeater with the ST32DVM board and two mobile radios. As of now, the repeater is configured DMR only. I noticed there is support for FM analog mode in pistar expert settings. Does the ST32DVM board support this mode directly? If so, what do I need to do to enable the mode? Tn...

Andy, I followed your instructions to allow the use TGIF and Brandmeister on my PI-Star repeater. I noticed the thread was from 2018. I have a problem. We use TGIF talk group 2416 so i configured the radio to use slot 1 for TGIF. All of a sudden i'm getting calls from Sweden which is TG 2416 on Bran...

Thanks for the tips!
I was able to get the hotspot working. Set Node Type to public.

Also corrected parrot.

Now to try to figure out why audio passes through on a Allunce HD-1 but not a Motorola XPR-6550 lol!
(i think i know the answer to that lol!)

Hello, Setting up my 3rd PI-STAR hotspot. this time using PI-STAR 4.1.0 ST32DVM PI hat connected to Motorola CM200 accessory port. I configured the software for simplex Radio is receiving signal, ST32DVM board is receiving signal. I thought all i had to do was select TGIF_Network from the config men...