Search found 5 matches

by KD8VIG
Fri Sep 14, 2018 6:04 pm
Forum: OLED Screens
Topic: OLED on ZumSpot
Replies: 9
Views: 2387

Re: OLED on ZumSpot

Hello, I followed the advice of testing the OLED on my Arduino Uno and it was working correctly. I then soldered it directly to the headers on the top of the ZumSpot and it began to work correctly! As was pointed out earlier, the I2C through-holes on the ZumSpot will not work for installing an OLED!...
by KD8VIG
Sun Aug 19, 2018 1:06 am
Forum: OLED Screens
Topic: OLED on ZumSpot
Replies: 9
Views: 2387

Re: OLED on ZumSpot

Yes, the pins all match. I am also getting 3.3V on the display. I notice in some configurations you need to run 'sudo raspi config' to setup the I2C, but the Pi-Star image doesn't allow that.

-Ryan
KD8VIG
by KD8VIG
Tue Aug 07, 2018 7:48 pm
Forum: OLED Screens
Topic: OLED on ZumSpot
Replies: 9
Views: 2387

OLED on ZumSpot

Hello, I now have an OLED display for my ZumSpot. It uses the I2C interface and I am having trouble getting it to work. I correctly soldered the +3.3V, GND, SDA, and SCL lines from the display to the through holes on the ZumSpot, just below the LEDs. In Pi-Star, I selected the display type as OLED, ...
by KD8VIG
Tue Jul 24, 2018 1:51 pm
Forum: OLED Screens
Topic: Color OLED Compatibility
Replies: 2
Views: 858

Re: Color OLED Compatibility

Ok thanks! That's what I needed to know!
by KD8VIG
Mon Jul 23, 2018 4:47 am
Forum: OLED Screens
Topic: Color OLED Compatibility
Replies: 2
Views: 858

Color OLED Compatibility

Hello, This is my first post on the Pi-Star Forums and I just recently setup Pi-Star on a ZumSpot device. I have noticed a lot of users are using the SSD1306 two color OLED displays. I would like to add a color OLED display using SSD1331 from Adafruit and I am not sure if it would work with the buil...