forum.pistar.uk

Disregard the above.....this was user error induced. New code seems to be working correctly.

W8NIN

Additional info: One one hotspot (MMDVM (GPIO) + Pi 3B) , I use the YSF parrot and I can key up, transmit, but get no audio on the transmission back from the parrot. The other hotspot (MMDVM (GPIO) + Pi Zero 2 W) for some reason with what I think are the same settings, works fine with the YSF parrot...

Hello,

My FT-70D needs a TX/RX Offset of -850 to -1500 offset depending on the MMDVM board. My FT-5D's need offsets of 0 (Zero) to work with the MMDVM board.

Use this like to find out what offset your radios need. https://www.k9npx.com/2019/02/hotspot-o ... ation.html

W8NIN

That might be part of the issue. When I was in duplex mode, Brandmeister would not show the hotspot I was on (It saw 01 and 02, both simplex, but 03 which was configured for duplex would not show up on the Brandmeister dashboard.) When I reconfigured it for Simplex mode....Brandmeister saw it just f...

Duplex offsets - 442.525 MHZ / 447.525 MHZ
Simplex 446.1500 MHz

So I'm not sure why my config is not compliant?

Regards,

Mike Doerner

Hi Andrew,

For TGIF, yes, this configuration works. For Brandmeister it does not. They (BM) check the frequencies of the hotspot. Hence my question.

If you want to check the discussion I had with Brandmeister about this issue on Telegram, be my guest.

Mike Doerner

Hi Andrew, The issue is the duplex configuration fails as it is rejected by Brandmeister. All I have done is changed from simplex 446.150MHz to 442.525 / 447.525 MHz for TX / RX in duplex and I can transmit fine, but no RX. Brandmeister says they blocked this configuration so I'm trying to figure ou...

Howdy Gents, So I’m having a specific Brandmeister problem with my dual-hat MMDVM when using 2 frequencies for RX/TX in duplex mode. I do not have this problem on the TGIF network so it is specifically a Brandmiester issue. I have tried to solve this issue with the Brandmeister Telegram USA group an...