forum.pistar.uk

Having run 4.3.0 in GB7HT - Raspberry Pi2 with ZumRadio V0.9 for sometime now I did an update this morning to receive notification of the need to burn 4.3.4 to upgrade further. The image fails to run at all in the Pi2..... but to check its viability I ran it in my test facility (Pi4) and it expanded ...

I've just run it again, and now the link is to /dev/pts/0 - There is no serial configuration.
I of course tried raspi-config to force it, but immediately it resets on reboot to the above.

sudo cat /dev/ttyAMA0 has an empty result likewise /dev/pts/0

/dev/serial0 does not exist.

So I edited the ...

I removed my original post as I thought that the BaudRate might have some bearing on why the Pi-Star fails to now communicate with the modem at ttyAMA0. However the MMDVHost includes the new baud rate and the correct port ttyAMA0. However on exploring the software further there has been added a ...

I have tried five times on the same image, if that's what you mean. Unsuccesful access to ssh. I even tried inserting 'raspberry' - Works on configuration after I clear the browser cache, but not on ssh

Running Beta - I have encountered a different issue. In changing the administration password for the configuration (happily accepted) this is not transferred to the Operating System password. The default 'raspberry' no longer works, so I cannot access ssh at all. Has there been an encrypted failure ...

OK. Understood. But this was occurring using the expert setting.... I'll watch it and see what happens on the eventual site-install. It's off until then - Thanks.

I have just rebuilt pi-star for F5ZLR in France, upgraded to 4.1.6 and installed everything as it was, however at every small subsequent change, the MMDVMHost gets reset to single slot working, despite duplex being the selected option in the configuration.
This reset occurs in the 'General ...

OK - So i've gone back to a previous commit. and I can now read the modem with findmodem.
Detected MMDVM (GPIO): /dev/ttyAMA0 (MMDVM 20180327 (D-Star/DMR/System Fusion/P25/NXDN) GitID #f898390)
Now I have an entirely different issue, in that MMDVMCAL works, and transmits perfectly, but when set back ...

Having already successfully compile this sometime ago for GB7HT, I tried to do the same to GB7NE, that has the identical board. The compilation works, and the STM reports successful completion. But when I restore the Pi-Services the modem fails with the following.

E: 2021-12-20 11:51:11.545 ...

Indeed I had one Debug switch on true so I have changed that. I will give another test period before I take it further. I know I'm not the only one with this issue.