Search found 10 matches
- Sat Dec 05, 2020 4:49 am
- Forum: DMR Specific Support
- Topic: pi-star repeater issue / DMR radio could hear network but not other radio to the repeater
- Replies: 0
- Views: 971
pi-star repeater issue / DMR radio could hear network but not other radio to the repeater
I have a MMDVM/Pi-Star based DMR repeater. I discover a problem when two DMR radio trying to do a local QSO via the repeater, they can't hear each other. But both could hear network talkgroup just fine. What could have cause this issue?
- Fri Nov 27, 2020 2:14 am
- Forum: Pi-Star General Support
- Topic: Time between modes to avoid QSO disruption.
- Replies: 7
- Views: 2487
Re: Time between modes to avoid QSO disruption.
Any clues on what settings maybe triggering this?
- Tue Nov 24, 2020 10:02 pm
- Forum: Pi-Star General Support
- Topic: Time between modes to avoid QSO disruption.
- Replies: 7
- Views: 2487
Re: Time between modes to avoid QSO disruption.
In practices, I observed that a DMR traffic initiated from Brandmeister ignored any Hang time settings and switch modes right after I unkeyed my D-Star radio.
- Tue Nov 24, 2020 7:33 am
- Forum: Pi-Star General Support
- Topic: Time between modes to avoid QSO disruption.
- Replies: 7
- Views: 2487
Re: Time between modes to avoid QSO disruption.
My RF and NET hang time are all set to default 300 which I think is 5 minutes. I don't know if it will prevent MMDVM to switch modes while a QSO is going on.
- Tue Nov 24, 2020 2:16 am
- Forum: Pi-Star General Support
- Topic: Time between modes to avoid QSO disruption.
- Replies: 7
- Views: 2487
Time between modes to avoid QSO disruption.
I have a repeater using Pi-Star and MMDVM for both DMR and D-Star mode. I find out that my D-Star QSO would be disrupted by traffic initiated from a DMR TalkGroup over the network. Is there a way to set Pi-Star to prioritized RF traffic and stick to a mode for x minute before allowing different mode...
- Fri Jul 10, 2020 2:53 am
- Forum: Pi-Star General Support
- Topic: Delayed Key-off in Duplex mode
- Replies: 0
- Views: 1333
Delayed Key-off in Duplex mode
I am using STM32-DVM with 2 Kenwood radio as a duplex repeater and running DMR with Pi-Star 4.1.2 I notice that since I switch it to Duplex from Simplex, the transmit radio will keep transmitting for a few seconds after the source has stopped talking. I don't know what is being transmitted when DMR ...
- Fri Jun 26, 2020 8:58 pm
- Forum: Other MMDVM Modem Boards
- Topic: Analog FM mode working on MMDVM Repeater
- Replies: 7
- Views: 25120
Re: Analog FM mode working on MMDVM Repeater
Could you show me how do you configure it to work FM Analog mode?
- Wed May 13, 2020 6:55 pm
- Forum: Pi-Star General Support
- Topic: link 2 Pi-Star together via LAN
- Replies: 10
- Views: 4676
Re: link 2 Pi-Star together via LAN
What software you could use to run YSF reflector?
- Tue May 12, 2020 5:22 pm
- Forum: Pi-Star General Support
- Topic: link 2 Pi-Star together via LAN
- Replies: 10
- Views: 4676
link 2 Pi-Star together via LAN
Is it possible to link 2 Pi-Star together using only LAN so that the 2 Pi-Star could function essentially as linked repeater?
- Thu Dec 19, 2019 10:23 pm
- Forum: DMR Specific Support
- Topic: DMRGateway for a custom server
- Replies: 0
- Views: 1521
DMRGateway for a custom server
I am trying to connect my Pi-Star to PNW Digital's server. However, I would like to use DMRGateway instead of custom DMR_Hosts.txt as that allows me to connect to PNW Digital and DMR2YSF at the same time. What I have tried right now is I go into config/expert/DMR GW and I change the settings for DMR...