forum.pistar.uk

I Was able to shorten and personalize the list of reflectors shown on the radio (obtained with the search 'ALL' on the Yaesu radio) By Default the list of reflectors is stored in the following location: /usr/local/etc/YSFHosts.txt This File is automatically updated by Pi-Star (I guess every night) I...

Hi Mike, When I started with pi-star I found very useful information on this guide: https://amateurradionotes.com/pi-star.htm In particular I suggest you to start reading from chapter 4, as from what you said, I understood you are at your first boot of the system. Because you are probably only using...

Good Evening, recently I am successfully using the YSF2DMR to connect DMR with my Yaesu Radios ( I use FT2, FT3, FTM400). I have realized that the voice audio level seems to be a bit higher (same on all the models I own). There are stations coming with a very strong audio, up to the point that they ...

n1id wrote: ↑Tue Feb 19, 2019 6:34 pm Everything seems to be working fine on my FT70D. However I have a question, when using ysf2dmr and setting talk group with wires x how do I connect to a six digit talk group. Thanks

I would like to understand if this is possible too.

It works and I am able to switch to any 5 digits TG (6 digit TG i guess is not supported) but it stay connected as far as someone is talking on the destination TG. As soon as the PTT is dropped on the TG then I am sent back to my original TG (set in Pi-Star). It is impossible to follow a QSO Luigi ...

It works and I am able to switch to any 5 digits TG (6 digit TG i guess is not supported) but it stay connected as far as someone is talking on the destination TG. As soon as the PTT is dropped on the TG then I am sent back to my original TG (set in Pi-Star). It is impossible to follow a QSO Luigi h...

On My FTM-400 only the ALL listing is working.
There is though no possibility to store any of the listed Reflectors as the error message message comes to be the same as for Direct Search, "No Data"

73
Luigi

I am going to describe how I do it on my handheld FT-2D and my zumspot. Setting on Pi-star: YSFStartup HOST: YSF00002 UPPERCASE Hostfiles WiresX Passthrough DMRid= your dmr id DMR Master= Your perferred Master Hotspot Security = empty DMR TG = your prefered startup TG On my radio: I press the X butt...

Oddly enough, when in YSF2DMR mode, it DOES populate the DMR talk group search results on the FTM400's but not the YSF/FCS. Something to do with host file? I tried with all caps, without all caps, with YSF2DMR enabled, YSF2DMR disabled, WIRES-X passthrough enabled and disabled... In fact if I do a ...