forum.pistar.uk

All done, got that crap figured out all by myself, with the gained knowledge of the 169.xxx.xxx.xxx IP addresses.

Thanks for the reply, I now understand the oddball IP address. Is there a fix for this?

Allen/W7BPA

I just got new fiber optic Internet along with a new router, 300 mbps service. I finally managed to get into Pi-Star's AP using 192.168.50.1 and configure the new re-flashed card. All went well until I got to the Wi-Fi configuration block. The network scan function worked ok and found my router. Aft...

My ZUMSPOT running the newest Pi-star Upgrade and Update has only one mode enabled, YSF. The "Target" column on the Admin page only displays DG-ID 0 instead of "All" or the current reflector. Can I modify this? The YSF Network block tells me where I am connected, but why did DG-I...

Is it possible to configure a Lonestar Duplex Hat on Pi-Star to operate in simplex mode yet enable both Time Slots? No, a Simplex hotspot can only run one timeslot. And I don't think you can run that hat in duplex and use the same TX and RX freq. Thank you for the response. I found the instructions...

Is it possible to configure a Lonestar Duplex Hat on Pi-Star to operate in simplex mode yet enable both Time Slots? I am attempting to use a cross band repeater radio (D578) Analog to Digital, and the instructions say that the Digital side of the crossband has to be a simplex frequency. I like to us...

I have acquired an EF Johnson 5100ES P25 radio. I have updated the FW, use the most current PCConfigure program and finally got it connected to my hotspot. However, when I Tx, there is a delay of 3 seconds between PTT and the actual transmission by the radio. I witness this on my Pi-star dashboard. ...

I am using an N5BOC Dual hat rpi 0w. I have the scripts (correct terminology?) loaded in DMR GW for DMR Network 4=TGIF and DMR Network 5=Prime TGIF. Currently Prime is coming through on both time slots (my dash board displays duplicate information, one for each TS). I have and have read the rewrite ...

Not a reply to the OP, but I have the same problem with cross moding into YSF from DMR Gateway. I am using an AT-878 and I have programed my Pi-Star through Expert Editor to include BM (DMR Network 1), DMR2YSF (DMR Network 3) and TGIF (DMR Network 4). When I cross mode to YSF, every one I talk to co...