Search found 9 matches
- Fri Apr 15, 2022 9:31 pm
- Forum: WiFi Setup
- Topic: Another "New Router/Internet" issue!
- Replies: 5
- Views: 8480
Re: Another "New Router/Internet" issue!
All done, got that crap figured out all by myself, with the gained knowledge of the 169.xxx.xxx.xxx IP addresses.
- Fri Apr 15, 2022 1:34 pm
- Forum: WiFi Setup
- Topic: Another "New Router/Internet" issue!
- Replies: 5
- Views: 8480
Re: Another "New Router/Internet" issue!
Thanks for the reply, I now understand the oddball IP address. Is there a fix for this?
Allen/W7BPA
Allen/W7BPA
- Fri Apr 15, 2022 5:55 am
- Forum: WiFi Setup
- Topic: Another "New Router/Internet" issue!
- Replies: 5
- Views: 8480
Another "New Router/Internet" issue!
I just got new fiber optic Internet along with a new router, 300 mbps service. I finally managed to get into Pi-Star's AP using 192.168.50.1 and configure the new re-flashed card. All went well until I got to the Wi-Fi configuration block. The network scan function worked ok and found my router. Aft...
- Mon Jul 12, 2021 3:18 am
- Forum: YSF Specific Support
- Topic: YSF "Target" information?
- Replies: 0
- Views: 2234
YSF "Target" information?
My ZUMSPOT running the newest Pi-star Upgrade and Update has only one mode enabled, YSF. The "Target" column on the Admin page only displays DG-ID 0 instead of "All" or the current reflector. Can I modify this? The YSF Network block tells me where I am connected, but why did DG-I...
- Mon Jun 28, 2021 4:12 am
- Forum: Pi-Star General Support
- Topic: Two Time Slots
- Replies: 1
- Views: 1556
Re: Two Time Slots
Is it possible to configure a Lonestar Duplex Hat on Pi-Star to operate in simplex mode yet enable both Time Slots? No, a Simplex hotspot can only run one timeslot. And I don't think you can run that hat in duplex and use the same TX and RX freq. Thank you for the response. I found the instructions...
- Sun Jun 27, 2021 12:50 am
- Forum: Pi-Star General Support
- Topic: Two Time Slots
- Replies: 1
- Views: 1556
Two Time Slots
Is it possible to configure a Lonestar Duplex Hat on Pi-Star to operate in simplex mode yet enable both Time Slots? I am attempting to use a cross band repeater radio (D578) Analog to Digital, and the instructions say that the Digital side of the crossband has to be a simplex frequency. I like to us...
- Sun May 09, 2021 2:03 pm
- Forum: P25 Specific Support
- Topic: P25 Radio Tx Delay
- Replies: 0
- Views: 6609
P25 Radio Tx Delay
I have acquired an EF Johnson 5100ES P25 radio. I have updated the FW, use the most current PCConfigure program and finally got it connected to my hotspot. However, when I Tx, there is a delay of 3 seconds between PTT and the actual transmission by the radio. I witness this on my Pi-star dashboard. ...
- Sun Apr 11, 2021 1:38 am
- Forum: DMR Specific Support
- Topic: DMR Network Scripts
- Replies: 0
- Views: 2367
DMR Network Scripts
I am using an N5BOC Dual hat rpi 0w. I have the scripts (correct terminology?) loaded in DMR GW for DMR Network 4=TGIF and DMR Network 5=Prime TGIF. Currently Prime is coming through on both time slots (my dash board displays duplicate information, one for each TS). I have and have read the rewrite ...
- Tue Jan 19, 2021 7:56 pm
- Forum: YSF Specific Support
- Topic: DMR to YSF
- Replies: 5
- Views: 4074
Re: DMR to YSF
Not a reply to the OP, but I have the same problem with cross moding into YSF from DMR Gateway. I am using an AT-878 and I have programed my Pi-Star through Expert Editor to include BM (DMR Network 1), DMR2YSF (DMR Network 3) and TGIF (DMR Network 4). When I cross mode to YSF, every one I talk to co...