Search found 112 matches

by W1KMC
Fri Jun 26, 2020 11:33 am
Forum: I'm new here
Topic: Jumbo Hot Spot defaults to TG 91
Replies: 2
Views: 99

Re: Jumbo Hot Spot defaults to TG 91

Best posted in the DMR specific board but: Short answer is nothing - you are doing nothing wrong. Pi-Star hotspots have a "feature" called pseudo-static where it remembers the last talkgroup you transmitted on, so if you had a power outage or sim,ply turn you hotspots off when not in use, the PiStar...
by W1KMC
Sat May 16, 2020 11:38 am
Forum: Pi-Star General Support
Topic: Btech DMR-6x2 HT
Replies: 8
Views: 536

Re: Btech DMR-6x2 HT

With the post by @KE7FNS giving me a clue of why I'm a dufus and not using my brain, I fired up the MMDVM_HS_Dual_Hat I had from a friend and flashed a new card. I found the modem to be the dual hat one by DB9MAT and crew/GPIO. I then did an MMDVMCAL and found the offset to be about -800 (got it dow...
by W1KMC
Fri May 15, 2020 9:59 pm
Forum: Pi-Star General Support
Topic: Btech DMR-6x2 HT
Replies: 8
Views: 536

Re: Btech DMR-6x2 HT

I have a friend when in simplex can hear just fine but the duplex board won't hear him - Pi-Star4.1.1 updated today (acxtually I made a new card to start fresh) I never thought of TX on Hotspot == RX on Radio -- see I have only used simplex (single antenna) boards. I had a friend give me two duplex ...
by W1KMC
Wed Apr 15, 2020 9:56 am
Forum: Pi-Star General Support
Topic: 2 Hotspots - 1 Network?
Replies: 3
Views: 435

Re: 2 Hotspots - 1 Network?

Yes, but to do this with BOTH turned on, use the IP to do the following: Hotspot #1 (change to real IP) http://192.168.1.X/ Configuration --> [Enter user pi-star // raspberry if asked] --> scroll down to Hostname Change this to a new name (e.g.) juliespot Apply changes At the reset of the screen, yo...
by W1KMC
Fri Mar 27, 2020 11:47 am
Forum: D-Star Specific Support
Topic: DMR to Dstar crossmode configuration
Replies: 4
Views: 579

Re: DMR to Dstar crossmode configuration

Cross posted to DMR board -- read my response there.
by W1KMC
Fri Mar 27, 2020 11:46 am
Forum: DMR Specific Support
Topic: DMR to Dstar crossmode configuration
Replies: 5
Views: 659

Re: DMR to Dstar crossmode configuration

Last I knew that is the ONE crossover that can't be done. DMR cross Modes are DMR2NXDN and DMR2YSF DSTar is not open source so as far as I know, it can't be done DMRby use of the DMR Gateway can use XLX REflectors, but Unless 001-C is tied into an XLX reflector, no go there either For XLX reflectors...
by W1KMC
Sun Jan 26, 2020 1:41 pm
Forum: Feature Requests
Topic: Allstar
Replies: 8
Views: 1320

Re: Allstar

we were You said that it was dead in raspbian, it's not but it DOES use old stuff already. OP asked if Allstar could be added, my short answer was NO. Even M1DNS said so (Admins, you have locked other threads like this real quick. I think you need to do the same here). Read my sig, I am NOT a guru -...
by W1KMC
Sat Jan 25, 2020 10:47 am
Forum: Feature Requests
Topic: Allstar
Replies: 8
Views: 1320

Re: Allstar

I ran into that and there is a post somewhere on the allstarlink or hamvoip or some forum about putting a HOLD on the kernel so it doesn't get updated and it works fine. The REAL problem is that the asterisk version they use went out with the dinosaurs (2.1, I think) Asterisk is now up to 16 so they...
by W1KMC
Sat Jan 25, 2020 1:57 am
Forum: Feature Requests
Topic: Allstar
Replies: 8
Views: 1320

Re: Allstar

Sorry, but as stated in this forum a few times now, AllStarLink is an analog mode. Pi-Star is Digital only, so adding Allstar is not possible. You could just make another Pi an allstar node but as to a radio board or how to connect a 'spare' radio to it, is not a discussion for this forum. Try hamvo...
by W1KMC
Mon Jan 13, 2020 1:54 pm
Forum: DMR Specific Support
Topic: Rewrite Rules in Simplex Node
Replies: 7
Views: 705

Re: Rewrite Rules in Simplex Node

Configuration --> Expert Mode -> DMRGATEWAY (under the full editor ) as the top one is in GUI form - the full editor show in textual form.