forum.pistar.uk

I'm running the model 8 layout which works well, but I am going to try the model 10 tomorrow. From what you have said, I believe the culprit for the change in baud rate, was that I first tried the screen on a RPi 4B with an MMDVM Dual Hat running thru the USB onto which I first tried adding the touc...

That looks good. And thank you for your assistance.

Roger

Done all that, and the screen was set on 115 200(!) and is now reading the test file correctly. Thank you. I have a couple of questions please: 1. Could I have changed the Nextion <layout> in the Pi configuration to ON7LDS L3 HS, to send the higher baud rate and would that have worked? 2. Running th...

Thank you. I’ll give it a try as you suggest.

Roger

Screen was working well. Touching screen produced message at the bottom, saying touch driver needed. Decided to install touch driver. Used NextionDriverInstaller. Nothing on screen. Touched screen and part of text appeared. Touched again, more appeared. Screen responded to brightness slider. Message...

Pins both ends are properly seated. It should be working - but isn't.

Roger

That can come later. I just want to get the screen back to its basic settings.

Roger

Those were the settings I used for the touch driver, with which I had problems. I just want the screen back to the basic state as it was before I installed the (touch) driver.

Roger

My screen is connected to the 4 pins on the modem and to the Pi by GPIO. The weird thing is that prior to the installation of the (Touch) driver, it was working fine (but with no touch).

Roger

I have a K series 3.5" screen, RPi Nano and Simplex MMDVM modem. All was working fine, but no touchscreen. I downloaded the On7LDS/NextionDriverInstaller and the touch screen sort of worked - if you touched it the first time, but the connection to the modem had stopped working; the screen showe...