forum.pistar.uk

Thanks, I have been trying to get a DMR private call on YSF2DMR to work, I added the callsign per instructions below. I can only RX the private call, when I try to TX back, they cannot hear me at all. Any ideas?

After further investigation changing my offsets actually made every other mode have a lot of errors. That means it was my radio that has a bad offset. Luckily the programming software allowed me to edit the offset on the radio. The carrier looks bang-on the SDR and there are almost 0% errors on all ...

Is there any specific setting I should look for in the radio programming? I honestly do not know. MMDVMCal should not care about what ID is programmed into the radio, it will allow all. If Pi-star is configured for private, it will only allow yours, if it is public it should allow all. I would conf...

I just did some more testing and my radio can RX the NXDN signal from the hotspot just fine, but I cannot transmit back to it. Is there any specific setting I should look for in the radio programming? Is the hotspot only looking for the RAN and ignores the rest of the header? I can specify talk grou...

Thanks, I just tried this and when in the test mode for NXDN, I don't see anything when trying to key up the hotspot. I adjusted the offset up and down and tried keying it up and still nothing reported :( Check frequency the hotspot is listening on. You said you used an SDR to confirm, so make sure...

Can anyone help point me in the right direction? It could be the offset is incorrect. Try MMDVMCal. Use this as a guide but use option 'n' instead of 'b' http://www.kh7ms.com/mmdvm/ Thanks, I just tried this and when in the test mode for NXDN, I don't see anything when trying to key up the hotspot....

Hello, I have a Icom F6061D radio programmed to the hotspot frequency. Whenever I key up the radio, the hotspot ignores the signal completely. I have made sure the RAN is correct and I also am using my NXDN ID from radioid.net. I have also tried both 'Individual' and 'TalkGroup' call types in the ra...