forum.pistar.uk

I now have YSF working again with 4.2.0 beta. The change that fixed it was setting LowDeviation to 1 in the MMDVMHost settings. Mode on my FT-3D is set to DN. I'll go away and research what this does. DN and VW mode have the same modulation parameters but use different codecs and hence the packet c...

I just ran it on a Pi Zero 2W running Pi-Star 4.2.0 with a HS_HAT clone on it and it happily updated it to v1.6.1 without any problems.

I've managed to build some firmware from a link Andy posted, although it's not resolved my YSF issue. There's also an on-line builder that produces V1.6.0 (but you have to know which switches to turn on!) https://forum.pistar.uk/viewtopic.php?p=24018#p24018 . I just cloned the Github then built it ...

I've just seen your post Brian after posing a similar question. What modems do you have, I'm using the MMDVM_HS_Dual_Hat clones, currently with v1.5.2 and all with STM32F10*. I agree with the 2W upgrades, it makes a noticeable difference over the W when using the dashboard interface. the 3A is also...

I have always used the passwd command to change the pi-star user password.

I then change the dashboard password separately.

Try after using rpi-rw at the command line via ssh.

Yes, I realise that, which is why I was asking. My HATs seem to all have STM32F1xx processors, and G4KLX appears to be saying that they won't work at the current serial baud rate. I am changing all my Pi Zero W boards to Pi Zero 2 W but of course the HAT needs to go faster in some circumstances. I'm...

Now that 4.1.18 has some M17 support, is there a good reason to install the v1.6.x firmware in the various HSHATs?

I realise it may be a little early.

You need to work out the link budgets for Tx and Rx, assume 0dB isolation between the antennas and use the ADF7021 phase noise plots to estimate the energy from the Tx at the Rx frequency. You also need to consider the blocking performance of the Rx against the Tx signal at +13dBm or similar. Full ...