Search found 139 matches
- Sun May 31, 2020 9:03 pm
- Forum: Pi-Star General Support
- Topic: MobileGPS
- Replies: 18
- Views: 16528
Re: MobileGPS
I had an old President Lincoln 10m radio in a truck that when I turned it on it would knock out my GPS signal on a handheld unit mounted on the dash, I ended up getting a higher gain external antenna. After a while the 10m just quit transmitting completely, I never knew what was causing it but mayb...
- Sun May 31, 2020 12:39 pm
- Forum: Pi-Star General Support
- Topic: MobileGPS
- Replies: 18
- Views: 16528
Re: MobileGPS
So I had some free time and dug out a GPS/compass unit for one of my fathers autonomous drone flight controllers, and I was able to configure it to spit out the NMEA messages, I also had it spitting out at a rate of 10hz, and 115200 baud just for funzies. They use the Ublox 6, 7 and 8 chips on most...
- Sat May 30, 2020 10:26 am
- Forum: Pi-Star General Support
- Topic: MobileGPS
- Replies: 18
- Views: 16528
Re: MobileGPS
Looks like MobileGPS is only looking for the NMEA sentences GGA and RMC everything else is ignored. You might need to plug that into the Ublox u-center and configure it and then confirm that yours is sending those NMEA messages. Its been a while since I've tinkered with a Ublox but I might see if I...
- Thu May 28, 2020 10:59 am
- Forum: Pi-Star General Support
- Topic: Unable to upgrade to 4.1.2
- Replies: 5
- Views: 3010
Re: Unable to upgrade to 4.1.2
3.4.17 is the latest you'll get for the 3.x.x You'll need to burn a new image in the 4.x.x to upgrade to the latest. 4.x.x was when the O/S changed.
- Sun May 24, 2020 4:25 pm
- Forum: Pi-Star General Support
- Topic: MobileGPS
- Replies: 18
- Views: 16528
Re: MobileGPS
Doesn't seem to like my U-blox7. Unless I didn't do something I'm supposed to. It shows up in LSUSB, but when I reboot after enabling mobilegps. I don't see anything. Checked for the mobilegps file in etc/ and it was nonexistent.
- Thu May 21, 2020 5:51 pm
- Forum: YSF Specific Support
- Topic: how to setup pi-star to automatically reconnect to the YSF Reflector if looses connection
- Replies: 6
- Views: 4040
Re: how to setup pi-star to automatically reconnect to the YSF Reflector if looses connection
Mine has Reconnect1 set to 0, and has always connected..
- Thu Apr 16, 2020 11:33 am
- Forum: IP Networking
- Topic: USB boot on Pi-zero w
- Replies: 5
- Views: 4124
Re: USB boot on Pi-zero w
Pi-star IS Raspbian. It just has some applications, scripts and tweaks added to the base lite image (and some applications removed). But it is just Raspbian. Ok, Raspian. So, the question still is: Can we have USB-ETH converter attached to use LAN ? If so, Any aditional packet needs to be installed...
- Fri Jan 17, 2020 8:02 pm
- Forum: Pi-Star General Support
- Topic: Pi-Star HTTP interface becomes unreachable with '504 Gateway Time-out'
- Replies: 12
- Views: 6328
- Wed Jan 15, 2020 1:31 pm
- Forum: DMR Specific Support
- Topic: Offset issues
- Replies: 7
- Views: 5217
Re: Offset issues
Link to a handy MMDVMCAL how-to in this thread: viewtopic.php?f=3&t=1309&p=5410&hilit=mmdvmcal#p5410
- Mon Jan 13, 2020 12:07 pm
- Forum: MMDVM_HS Hat(s)
- Topic: Pi-Star Cannot Read Modem's Firmware Version
- Replies: 8
- Views: 6990
Re: Pi-Star Cannot Read Modem's Firmware Version
Are pins 38 and 40 connected between the MMDVM and the PI? Failed to Init usually means they're not.