Search found 984 matches
- Sat Feb 17, 2024 2:14 am
- Forum: Pi-Star General Support
- Topic: mmdvmhost.service looping after upgrading to 4.2.1
- Replies: 5
- Views: 496
Re: mmdvmhost.service looping after upgrading to 4.2.1
OK I pulled the update, in the mean time try this: check and see if /etc/systemd/system/mmdvmhost.service.requires exists, and if it does remove the whole folder, and run sed -i '/Requires=nextiondriver\.service/d' /lib/systemd/system/mmdvmhost.service systemctl daemon-reload and then reboot. See if...
- Sat Feb 17, 2024 2:11 am
- Forum: D-Star Specific Support
- Topic: Loss of ttyAMA0 with 4.2.0
- Replies: 21
- Views: 1725
Re: Loss of ttyAMA0 with 4.2.0
Yep. 3 of my Pi-Star 4.2.1 hotspots are sitting there and continuously restarting, going offline, initialising, rinse and repeat. check and see if /etc/systemd/system/mmdvmhost.service.requires exists, and if it does remove the whole folder, and run sed -i '/Requires=nextiondriver\.service/d' /lib/...
- Sat Feb 17, 2024 2:02 am
- Forum: D-Star Specific Support
- Topic: Loss of ttyAMA0 with 4.2.0
- Replies: 21
- Views: 1725
Re: Loss of ttyAMA0 with 4.2.0
Well damn
EDIT: Update pulled, I'll figure it out tomorrow.
EDIT: Update pulled, I'll figure it out tomorrow.
- Fri Feb 16, 2024 9:19 pm
- Forum: Announcements
- Topic: RELEASE 4.2.1 - Upgrade and new Image
- Replies: 1
- Views: 4780
RELEASE 4.2.1 - Upgrade and new Image
4.2.1 fixes a couple of bugs, namely NTP issues and 1/2 baked NextionDriver install that had 2/3 of what was required, now NextionDriver should work properly and is pre-installed in this version. If you already have NextionDriver loaded, the upgrade should not make it any worse, although if you modi...
- Fri Feb 16, 2024 9:16 pm
- Forum: ZUMSpot (Hat / Libre / USB)
- Topic: The Rx field not displaying the Rx freq
- Replies: 2
- Views: 885
Re: The Rx field not displaying the Rx freq
4.2.1 has pretty decent support for NextionDriver now, but even so, some fields are not coming over properly.
There is a request open upstream for that, but it might take a little while for it to get fixed.
There is a request open upstream for that, but it might take a little while for it to get fixed.
- Fri Feb 16, 2024 9:14 pm
- Forum: Raspberry Pi Foundation Hardware
- Topic: Raspberry Pi 5 and MMDVM hat
- Replies: 1
- Views: 1778
Re: Raspberry Pi 5 and MMDVM hat
I don't think any adaption is required, other than making sure you don't reset anything that matters on a conductive heatsink... that is the only place you need to look at.
I used one of those header extentenders during testing to give the fan room to breathe.
I used one of those header extentenders during testing to give the fan room to breathe.
- Fri Feb 16, 2024 9:13 pm
- Forum: D-Star Specific Support
- Topic: Loss of ttyAMA0 with 4.2.0
- Replies: 21
- Views: 1725
Re: Loss of ttyAMA0 with 4.2.0
Update to 4.2.1 and let me know if that cures it for you
- Fri Feb 16, 2024 9:12 pm
- Forum: Pi-Star General Support
- Topic: 4.3.0 Beta feedback
- Replies: 57
- Views: 5969
Re: 4.3.0 Beta feedback
I'll try and squash some of these issues over the weekend.
- Wed Feb 14, 2024 12:24 am
- Forum: MMDVM_HS Hat(s)
- Topic: Cannot get the control attributes
- Replies: 6
- Views: 1322
Re: Cannot get the control attributes
I added some extra checks around NextionDriver (I think that is actually the cause in this case)
So it should not happen any more after an update.
So it should not happen any more after an update.
- Tue Feb 13, 2024 10:28 pm
- Forum: D-Star Specific Support
- Topic: Loss of ttyAMA0 with 4.2.0
- Replies: 21
- Views: 1725
Re: Loss of ttyAMA0 with 4.2.0
NextionDriver is the software that will do that, but it should not imact the system when you don't need it to.
I have added an extra check to stop it running when not required.
Update -> Apply changes on the config page -> reboot
Let me know if the problem is gone after that.
I have added an extra check to stop it running when not required.
Update -> Apply changes on the config page -> reboot
Let me know if the problem is gone after that.