Raspberry Pi 1

Help with Raspberry Pi Foundation Boards (Raspberry Pi, Pi Zero, Pi Zero W, Pi A, Pi B, Pi B+, Pi2 B, Pi3 B, Pi 3 B+)
Post Reply
VE6DV
Posts: 18
Joined: Sun May 13, 2018 4:34 pm
Location: Edmonton, Alberta

Raspberry Pi 1

Post by VE6DV » Wed Aug 07, 2019 12:36 am

Will Pi-Star 4.1 run on a Raspberry Pi 1 Model B revision 1.2? Or is the pi 1 too old to be able to run the software?
73 - Jeff VE6DV

User avatar
KE0FHS
Posts: 912
Joined: Wed Apr 11, 2018 8:40 pm
Location: Colorado, USA
Contact:

Re: Raspberry Pi 1

Post by KE0FHS » Wed Aug 07, 2019 1:09 pm

Have a look at this post by Andy, MW0MWZ: viewtopic.php?f=16&t=1273
"This image should work on every Raspberry Pi foundation board, from the original A board up to the latest Pi 3 A+ all using the same image."

I think the chances are very good that you should be able to run either the latest stable release, 3.4.17, or the latest beta release, 4.1.0-RC2 (with an upgrade to RC3 available) using a Pi 1B board.
73, Toshen, KE0FHS
Playing with Pi-Star (unofficial notes about setting up and using Pi-Star):
https://amateurradionotes.com/pi-star.htm

VE6DV
Posts: 18
Joined: Sun May 13, 2018 4:34 pm
Location: Edmonton, Alberta

Re: Raspberry Pi 1

Post by VE6DV » Wed Aug 07, 2019 1:54 pm

Thanks, Toshen. I appreciate the info.
73 - Jeff VE6DV

User avatar
VK7HSE
Posts: 161
Joined: Sun Apr 15, 2018 6:35 pm
Contact:

Re: Raspberry Pi 1

Post by VK7HSE » Thu Aug 08, 2019 11:18 am

My first pi-star install was on my original model B, granted it was on the 3.5x release. But the point of using the raspbian as pi-star base does ensure backwards compatibility. The only thing that you will strike is if you attempt to use a gpio hat it's going to be for the model a+/b+ 40 pin gpio but you can get around that with using a header riser, you would just have to manually put the hat into firmware update mode when doing any firmware updates because those pins are not available on the original model A/B boards (26 pin gpio)

Sent from my Pixel 2 XL using Tapatalk


VE6DV
Posts: 18
Joined: Sun May 13, 2018 4:34 pm
Location: Edmonton, Alberta

Re: Raspberry Pi 1

Post by VE6DV » Thu Aug 08, 2019 6:13 pm

Scott, thanks for the information. This particular pi is only being used for D-STAR using a 70 cm DVAP plugged into the usb port. So that shouldn't be an issue at this point. I inherited the original pi 1 from a friend that wasn't using it and figured I would put it to good use as another hotspot. It is currently running QnetGateway and is running quite well. I was just curious if the old hardware would also be able to run Pi-Star. I may give it a go and see what happens.
73 - Jeff VE6DV

Post Reply