Nextion not reading card?
Posted: Thu Feb 07, 2019 5:11 pm
Folks,
I have taken a couple of SD cards and reformatted them to FAT32. Placed the MMDVMHost/Nextion_G4KLX/ tft file, the one for the screen I have, a NX3224K024, on the SD cards (a 2G and a 16G) insert card into screen and all I see is:
Baud: 9600
SD Card Update.....
Unless it takes and extra ordinary amount of time to read even at 9k6b/s it should after a while clear and I believe as I understood, go to the screen on the new file. At that rate if my numbers are correct it should take about 12 minutes to load the file.
Any ideas of what maybe wrong ? If I power it down and remove the card, the power it up it goes back to the original screens with animations etc. I even removed the two data lines to make sure that was not going to cause an issue.
I have taken a couple of SD cards and reformatted them to FAT32. Placed the MMDVMHost/Nextion_G4KLX/ tft file, the one for the screen I have, a NX3224K024, on the SD cards (a 2G and a 16G) insert card into screen and all I see is:
Baud: 9600
SD Card Update.....
Unless it takes and extra ordinary amount of time to read even at 9k6b/s it should after a while clear and I believe as I understood, go to the screen on the new file. At that rate if my numbers are correct it should take about 12 minutes to load the file.
Any ideas of what maybe wrong ? If I power it down and remove the card, the power it up it goes back to the original screens with animations etc. I even removed the two data lines to make sure that was not going to cause an issue.