Page 1 of 1

OLED with Rpi3 & Zumspot USB

Posted: Wed May 08, 2019 5:39 pm
by K3SZ
I realize this is not a typical setup but I had terrible performance with a Win10 PC and the Zumspot USB. I plugged the device into a Pi-Star imaged RPi3 and it works great. My question is will the usual 1.3" OLED display receive and display data through the GPIO connections on the RPi3 if I tell Pi-Star there is a display -- the same config as if it were the standard Zumspot & PiZero (which I know does work). I don't have another OLED to test this thus the question I pose here.

Re: OLED with Rpi3 & Zumspot USB

Posted: Mon Jun 03, 2019 2:03 am
by K3SZ
@KE7FNS,

That makes sense. Realize now GPIO is not used for this.

Thanks!