Page 1 of 1

Increase display hang time?

Posted: Tue Jun 26, 2018 1:14 am
by W4AEQ
I just installed the OLED on my HS_HAT v1.3.7 and it works as advertised.
Is there a setting to increase the time before the screen defaults to the "scrolling MMDVM" display? Sometimes, by the time I get over to the unit to look at the data, it's already gone.

Thanks!

Re: Increase display hang time?

Posted: Tue Jun 26, 2018 6:18 am
by wb6dtb
The RF and NET mode timers on the configuration page control how long a mode remains locked on after the mode activity ends. This also affects the OLED display time.

Re: Increase display hang time?

Posted: Tue Jun 26, 2018 12:31 pm
by W1KMC
That's what I was thinking as well.

But does anyone now how to rotate the display 180 degrees? I run a Pi0WH with the chinese board where the OLED is soldered to the radio board only, It works fine - Love it. BUT

The power is on a side that makes standing upright impossible -- placing the case so the display reads upside down make the power USB on top -- it would be nice to rotate the display so it reads right side up and the flat long ege makes it stale on a desk or display table at demonstrations.

A Nextion Display would be a nicety but I don't have one, and I CAN use my tablet with IP/mobile (My android tablet wont take the http://jumbospot/mobiloe so I use http://ip.ad.dr.es/mobile/ and it will show nicely in landscape mode but that is another piece to carry and power. rotating 180 degrees would be SO much easier.

Re: Increase display hang time?

Posted: Sun Jan 13, 2019 10:01 am
by EA3BIL
Hi,

Sorry to take this old item "back to live"...

I hope you've already fixed the OLED upside-down displaying.

Anyway and just in case here you have the explanation:

Config, Expert, MMDDVMHost, OLED Section, ROTATE:
Value 0, text starts by te antenna.
Value 1, text ends by the antenna