Page 1 of 1
P25 & NXDN reset timer
Posted: Fri Jun 07, 2019 8:03 pm
by M6NBP
At this time when using Pi-Star via a repeater you can net set a reset / revert on P25 and NXDN
Would be nice if we could do the same as YSF Fusion = "YSF Startup Host: None"
And revert 15 mins
When running a mix mode repeater all modes to be used should time out at 15 mins when not in use or called.
Also could you add for both NXDN and P25 a TG 9 for local chat only via the repeater.
Many thanks
Norman M6NBP
Re: P25 & NXDN reset timer
Posted: Sat Jun 08, 2019 9:34 am
by M6NBP
Thank you for that info
.
Re: P25 & NXDN reset timer
Posted: Thu Jul 11, 2019 6:06 pm
by M6NBP
Code: Select all
At this time when using Pi-Star via a repeater you can net set a reset / revert on P25 and NXDN
Would be nice if we could do the same as YSF Fusion = "YSF Startup Host: None"
And revert 15 mins
Has this been looked into ??
.
Re: P25 & NXDN reset timer
Posted: Sat Jul 13, 2019 1:41 pm
by MW0MWZ
There has been a discussion about this on this board - the options can be there, you must need to use the expert editor to set it.
Re: P25 & NXDN reset timer
Posted: Sat Jul 13, 2019 4:21 pm
by M6NBP
I have looked through the forum and can not find the answer.
I know I need to add code.
But not 100% where to add the code
Can you please post the info again...
..
Re: P25 & NXDN reset timer
Posted: Sat Jul 13, 2019 6:56 pm
by M6NBP
I have added this below
nano /etc/nxdngateway
[Network]
InactivityTimeout=15
Revert=1
It seams to be working but when it times out I get this message = Service Not Started
- Capture.JPG (14.86 KiB) Viewed 2578 times
I get this message even when I have it set to go to worldwide or None
I take it I have done something wrong.
.