Page 1 of 1

Update to latest YSFGateway code

Posted: Wed Mar 25, 2020 4:34 pm
by kb2ear
Please update to the latest YSFGateway code so we can support the FT3 GPS and add Wires-X passthrough for XLX. I have compiled the latest code from github and replaced the included binary without any issues.

73,
Scott KB2EAR

Re: Update to latest YSFGateway code

Posted: Wed Mar 25, 2020 8:21 pm
by K2IE
@KB2EAR, thanks for calling my attention to this. I installed the updated G4KLX code for YSFGateway today on my RC8 system and it works wonderfully. I am now able to switch modules on my XLX.

Tom, please give consideration to incorporating this at the earliest possibility.

73,

Dan K2IE

Re: Update to latest YSFGateway code

Posted: Wed Mar 25, 2020 10:16 pm
by M1DNS

k2dls wrote:
Tom, please give consideration to incorporating this at the earliest possibility.

73,

Dan K2IE
Tom. ??

There's a possible issue found in the new YSFgateway release, so currently work in progress.


Sent from my SM-G935F using Tapatalk



Re: Update to latest YSFGateway code

Posted: Thu Mar 26, 2020 12:47 am
by K2IE
Ha-

I know of someone named Tom Taylor, so I suppose my brain is scrambled from too much social distancing! Apologies to Andy, Tom or whoever is behind that curtain. :)

73

Re: Update to latest YSFGateway code

Posted: Thu Mar 26, 2020 5:58 pm
by MW0MWZ
Pulled built and punted into the update system... but...

It mostly works, but the passthrough code still needs some work. I'll see if we can come up with a work-around for that.

Re: Update to latest YSFGateway code

Posted: Thu Mar 26, 2020 6:29 pm
by kb2ear
What kind of issues are you seeing? I have been testing for a few days and all works as expected.

Re: Update to latest YSFGateway code

Posted: Thu Mar 26, 2020 6:30 pm
by K2IE
Thanks very much Andy.

73

Re: Update to latest YSFGateway code

Posted: Thu Mar 26, 2020 10:05 pm
by MW0MWZ
kb2ear wrote:
Thu Mar 26, 2020 6:29 pm
What kind of issues are you seeing? I have been testing for a few days and all works as expected.
When you connect to an XLX, you then have to turn off Wires-X mode and turn it back on again to be able to control where you are linked on the XLX.

With the rest of the pass-through systems that is not the case, this is due to the way WiresX commands (and the replies) are targeted.

Re: Update to latest YSFGateway code

Posted: Fri Mar 27, 2020 12:50 am
by kb2ear
I thought that was normal, as I have had to back out and come back in to YSF2NXDN and YSF2P25 for as long as I can remember. But in playing with it today I see that I can get a room list from YSF2NXDN but it takes 2 tries to connect to a room. And the same on YSF2P25. I think that may be because of the voice announcement killing the ack.

But anyway, at least is usable as it sits now.

Thanks for all of your efforts & 73,
Scott KB2EAR