Yeah, I checked as far as I could without a schematic. Pin 38 only to the first 10k resistor in line. Pin 40 I was able to trace to a cap, through a 10k resistor then it splits off, feeding the PWR led and also going underneath to a unpopulated 10 pin surface mount position before I lose it. But it was good up till then.n9mxq wrote: ↑Sun Jun 10, 2018 6:03 pmUsually when this is seen, pins 38 and 40 aren't connected to the hat.. I'd check to make sure they are, and that they are properly soldered.KI7YNI wrote: ↑Sun Jun 10, 2018 8:03 am Never mind, it does error flashing it. Just it says it was successful at the end so I didnt really look at it.Code: Select all
Using Parser : Raw BINARY Interface serial_posix: 57600 8E1 Failed to init device.
Yeah, problem is I already soldered directly to it for a Nextion screen. I thought my issue was a network issue, since it wasnt connecting, so I went down the wrong rabbit hole and, finding a issue with my network, I spent probably 8 hours over 3 days figuring it out before deciding to apply a bandaid fix that got my network working fine again for now. But during which time I tinkered with getting the screen connected.
If I cant get it to work, Ill file it in the round filing cabinet and buy the other hat.