Page 1 of 1

BER Rate

Posted: Thu May 23, 2019 4:57 pm
by kb5wck
Is there a way to adjust the BER for YSF radios into the PiStar?

Re: BER Rate

Posted: Thu May 23, 2019 8:10 pm
by M1DNS
Yes the same as any other mode

pi-star/admin/expert click mmdvm host and make small adjustments to the Rx offset.

Sent from my SM-G935F using Tapatalk



Re: BER Rate

Posted: Fri May 24, 2019 1:16 am
by w7efs
While that might be true for direct RF to the Pi-Star G4KLX-driven radio, exclusive of the individual communicating radio's problems, the Internet digital aspects introduce other uncontrollable variables. E.g., someone communicating with their mobile hotspot using a speaker microphone to their HT on a belt-clip, introducing signal attenuation based on body position relative to the Pi-Star antenna.

By the way, "BER" is an acronym for bit error rate, so the OP's Subject: "BER rate" is redundant, entirely forgivable, though ... you can say that again. Language conveys meaning.

Re: BER Rate

Posted: Sun May 26, 2019 2:09 am
by kb5wck
Thanks. Wondered if that was the case.