forum.pistar.uk

KC2CBD wrote: ↑Wed Jun 05, 2019 9:40 pm I let the normal config do the setup then I edit the dstar configs in expert and it changes all the callsigns for everything to what I edit in the expert mode.
It didn't do that in v3 but it is now in v4.
I really would like to use v4 and edit the callsigns for what we need.
I don't know what is going on but it doesn't want to let me set different callsigns.

Thanks
Dale, KC2CBD

I do appreciate that you dont believe me, but the dashboards on v3 and v4 are the exact same, so the way the files are edited using the expert tool, and where the callsigns show up - is all the same.

Something isnt the same between your two setups (other than the V3/V4 build)

I do believe you but I'm also seeing what it is doing.
I just did it again and it is changing everything from the ircddbgateway expert config.

We need it to not change all of them.
We need different callsign for D-Star so need a way to allow this configuration.
Pi-Star is an easier system for our remote repeater.

I'm also having an issue with setting up the Headless MMDVM Due firmware Building.
We are using the Zum MMDVM on a Arduino Due.
I followed http://wiki.pistar.uk/Headless_MMDVM_Firmware_Building and forced arduino-1.8.6-linuxarm.tar.xz.
Still not working after making sure to have the dependencies for cross-compilation.

Thanks
Dale, KC2CBD