Page 1 of 1
CW ID Does not give full repeater call sign
Posted: Mon Oct 07, 2019 8:38 pm
by WD4W
The CWid feature works but it only gives a couple letters of the repeater call sign.
I am using Pi-Star:4.1.0-RC2 / Dashboard: 20190905.
My repeater keys up for 3 seconds and then only sends a partial call sign. Has anyone else had this issue?
Re: CW ID Does not give full repeater call sign
Posted: Tue Oct 08, 2019 5:41 am
by w7efs
WD4W wrote: ↑Mon Oct 07, 2019 8:38 pm
...
I am using Pi-Star:4.1.0-RC2 / Dashboard: 20190905.
...
Pi-Star:4.1.0-RC6 / Dashboard:20190905 here. Many transient issues have been addressed in updated/upgraded release candidates, so choose Configuration->Expert, and then Update followed by Upgrade a few times to get current. Afterwards, let the forum know if that solved the issue, please.
Re: CW ID Does not give full repeater call sign
Posted: Tue Oct 08, 2019 2:53 pm
by WD4W
Updated to Pi-Star:4.1.0-RC3 / Dashboard:20190905
Still has the same problem.
Does the CWid work properly on your Pi-Star system?
If it does work as it should on your system then the problem could be with my hardware.
I will wait for your response before troubleshooting any further.
Re: CW ID Does not give full repeater call sign
Posted: Tue Oct 08, 2019 7:57 pm
by M1DNS
RC6 is current.
Keep going with the update / upgrade process until you reach Release Candidate 6. and try agn.
Andrew M1DNS, (Mod)
Re: CW ID Does not give full repeater call sign
Posted: Tue Oct 08, 2019 8:53 pm
by KD8DVR
Works fine on all 5 of my pi star hotspots.
Sent from my SM-A102U using Tapatalk
Re: CW ID Does not give full repeater call sign
Posted: Wed Oct 09, 2019 7:11 pm
by K7ITE
Using the OpenGD77 as a hotspot I am unable to get consistent CW ID with either the Zero or the 3A. Both are at RC6.
This is a setup that would really benefit from ID. I've presumed the ID time would be consistent whether I'm transmitting or not but now wonder if it's only when it sees xmit activity. e.g. SW ID time = 10 would xmit every 10 minutes IF active, not so in idle listening mode.
Re: CW ID Does not give full repeater call sign
Posted: Tue Feb 25, 2020 5:12 pm
by kd2lh
Recent updates of GD77 firmware now fully support the CWID.