Page 1 of 1

two XLX Modules one repeater

Posted: Thu Jun 11, 2020 3:55 pm
by W8DSB
All, we have a repeater running PI-STAR with a STM32 board. I would liek to have Slot1 connect to XLXxxx module B and SLot2 connect to XLXxxx module A. Is there any way to do that in the current build? I know I can use HBlink but was hoping for a internal solution.

NOTE: The repeater has limited access so it is still running 3.4.17 until this years visit, then I will swap SD Cards.

Re: two XLX Modules one repeater

Posted: Tue Jun 16, 2020 6:54 pm
The XLX connectivity that is built into DMRGateway is designed for a single target, and a single time-slot, in short the way to do what you want is to get creative :)