I WAS running my Alinco MD5 into a Jumbo hot spot from my apartment. I was very happy with its performance
I then added a 10000mah battery pack (i know it is over kill) to power my internal hot spot.and my IPhone 6 to be used as my personal hot spot.
I tried it with out with no success in a local shopping centre
Back in the apartment, the iPhone did show that it was operating as a personal hot spot.
Except I could not transmit in this mode
Closed it & went back to my original set up using my apartment’ wifi.
The Jumbo hot spot booted up but there was no communication
I was also was unsuccessful in attempting to reach my config page @ Pi-Star
I then went to check if I had an IP Address. it was not posted
There is a generic IP address that can be used but it did not work either.
My Wifi in the config. file is set up as follows:
Number “0” is set up for a test set up
Number “1” is set up with my apartment wifi network
.
Number “2” is what I set up for my personal hot spot.
Right now the Jumbo hot spot boots up
With no IP address I can no longer can use my radio thru my apartment WiFi.
I do not know if I have one issue or two.
What I do know is that i can not use my radio.
No local wifi
no personal hot spot &
i can not reach any repeater from my apartment.
I would appreciate if someone could help me in resolving this issue.
Nat
VE2NGQ
hot spot not working
Re: hot spot not working
Ok i thank you for yr reply, I will go thru your response and see if I can solve my issue(s).
IN regards to the IP Address it was active yesterday morning. Three hours later it was no longer active. I am using the APP : Fing. i can see the address in the program but it not active.
Thanks let me go thru your suggestions and get back to you
Nat
VE2NGQ
IN regards to the IP Address it was active yesterday morning. Three hours later it was no longer active. I am using the APP : Fing. i can see the address in the program but it not active.
Thanks let me go thru your suggestions and get back to you
Nat
VE2NGQ
Re: hot spot not working
I would like to thank those who responded to my request for help to fix my 2 hot spots.
I now have the 2 units up and running.
Once again thanks
Nat
VE2NGQ
I now have the 2 units up and running.
Once again thanks
Nat
VE2NGQ