Hi,
n the oled led layout(DMR), from june i think, the layout was changed a bit.
its now more squashed up.
how come it was changed?
and is it possible to revert.
ip also used to be shown at all times too, but its now only at rest.
any thoughts please?
n
change to screen layout
Re: change to screen layout
What about IP not showing??
It shows for a really short time (flash) and goes when RF rx finish.
How to have it showing as it used ?
It shows for a really short time (flash) and goes when RF rx finish.
How to have it showing as it used ?
73'Rafael.
EA3BIL
JN11an
EA3BIL
JN11an
Re: change to screen layout
Sorry for long time to comment...
The request/comment was about OLED but Nextion.
I know quite well how Nextions deal with the information.
Do you really think a "Add a Nextion" is reasonable option for a JumboSpot size device ??
Really??
I have NOT edited/modified the original Pi-Star software so, IP not showing at bottom 0.96" type 3 OLED line is a common issue.
All the Simplex HSs I have checked ( more than 12 units) go on the same problem.
So, I should repeat question:
Why IP is not showing while RF RX by HS as it used to do???
If it should be showing...
What is the proper configuration for this to happen???
The request/comment was about OLED but Nextion.
I know quite well how Nextions deal with the information.
Do you really think a "Add a Nextion" is reasonable option for a JumboSpot size device ??
Really??
I have NOT edited/modified the original Pi-Star software so, IP not showing at bottom 0.96" type 3 OLED line is a common issue.
All the Simplex HSs I have checked ( more than 12 units) go on the same problem.
So, I should repeat question:
Why IP is not showing while RF RX by HS as it used to do???
If it should be showing...
What is the proper configuration for this to happen???
73'Rafael.
EA3BIL
JN11an
EA3BIL
JN11an