Unable to Switch Back to 'rpi-ro'

General support for the Pi-Star System
KD8DVR
Posts: 96
Joined: Tue Aug 14, 2018 6:23 pm
Location: Columbus, OH USA
Contact:

Re: Unable to Switch Back to 'rpi-ro'

Post by KD8DVR »

W4JEW wrote:Out of curiosity have you rebooted since disabling AutoAP?
Repeatedly. The error has been continuous for months now.

Sent from my SM-A102U using Tapatalk

AntiSquid Disclaimer: All messages posted are personal opinion only and may not constitute fact.
W4JEW
Posts: 58
Joined: Sun Aug 12, 2018 12:53 am
Location: Atlanta, GA, United States
Contact:

Re: Unable to Switch Back to 'rpi-ro'

Post by W4JEW »

Ok that’s what I thought. Hopefully Andrew can weigh in here as to what’s going on.
Check out GeorgiaDMR.net - https://www.georgiadmr.net
And on Groups.io - https://groups.io/g/GeorgiaDMR

Jeff Hochberg
W4JEW
Atlanta, GA
KD8DVR
Posts: 96
Joined: Tue Aug 14, 2018 6:23 pm
Location: Columbus, OH USA
Contact:

Re: Unable to Switch Back to 'rpi-ro'

Post by KD8DVR »

W4JEW wrote:Ok that’s what I thought. Hopefully Andrew can weigh in here as to what’s going on.
Yeah. Would be nice

Sent from my SM-A102U using Tapatalk

AntiSquid Disclaimer: All messages posted are personal opinion only and may not constitute fact.
KE7FNS
Pi-Star Team
Posts: 1944
Joined: Wed Apr 17, 2019 11:11 pm

Re: Unable to Switch Back to 'rpi-ro'

Post by KE7FNS »

I'm pretty certain the issue is caused by apt-daily.service.
If someones previous actions are any indication of their future actions, then I predict the deletion and removal of access will happen at any moment. 7-11-2020.

"07/13/20 This Website Has Been Taken Down" ... again :lol:
W4JEW
Posts: 58
Joined: Sun Aug 12, 2018 12:53 am
Location: Atlanta, GA, United States
Contact:

Re: Unable to Switch Back to 'rpi-ro'

Post by W4JEW »

Thanks so much for your contribution! I’m glad to see more activity on this thread since the last time I raised the issue. I hope others can add to this so we can get a good idea of how widespread the issue is. I would have to think that there is a large population that is experiencing it, my fear is that many don’t monitor this forum, so they won’t be able to share their experience.

Seems possible - then again, just about anything is possible.

If you run ‘lsof’ to see what files are open at any given time, the list is long and painful to review.

This really needs someone that can pinpoint exactly what the issue is so it can be put to bed once and for all.
Check out GeorgiaDMR.net - https://www.georgiadmr.net
And on Groups.io - https://groups.io/g/GeorgiaDMR

Jeff Hochberg
W4JEW
Atlanta, GA
KN2TOD
Posts: 104
Joined: Sun Nov 11, 2018 6:36 pm

Re: Unable to Switch Back to 'rpi-ro'

Post by KN2TOD »

FWIW:

I have five hotspots, configured as follows:

Hostname PI: *vers status Display Run
pi-star-1 3B+ 3.4.17 RW Nextion 24/7
pi-star-2 P0 3.4.17 RO - -
pi-star-3 P0 -RC6 RO - -
pi-star-4 P0 3.4.17 RO OLED -
pi-star-5 3B+ -RC6 RW Nextion 24/7

All are configured with Zumspot's with the latest firmware (1.4.17).

Hotspots 1 and 5 run pretty much 24/7, without reboots, weeks on end. The Pi-zero's are run intermittently,
for perhaps a couple hours per week. Also, HS's 1 and 5 are hard-wired, whereas the Pi-zero's connect via WiFi.

All boot into a read-only state, but over time, 1 and 5 eventually get stuck in write mode (RPI-RO has no effect).

Odd that the ones stuck in RW are running Nextion Drivers, but that may be coincidental; the up-time seems to be the relevant factor here as far as my setup goes.
AF6VN
Posts: 592
Joined: Fri Jul 20, 2018 1:15 am

Re: Unable to Switch Back to 'rpi-ro'

Post by AF6VN »

KN2TOD wrote: Wed Oct 09, 2019 12:07 pm Odd that the ones stuck in RW are running Nextion Drivers, but that may be coincidental; the up-time seems to be the relevant factor here as far as my setup goes.
Coincidence probable. About once a month my R-pi 3B running 3.4.17 will be found in RW and require a reboot to clear. No display attached, it's sitting on top of a china cabinet near the center of the house.

--
AF6VN
Dennis L Bieber
KN2TOD
Posts: 104
Joined: Sun Nov 11, 2018 6:36 pm

Re: Unable to Switch Back to 'rpi-ro'

Post by KN2TOD »

Great! As Jeff suggests, more feedback is needed, more observations to see if one can narrow down the contributing factors to the issue - a "survey" of some sort perhaps:

1) How often does the issue arise (how prevalent is the issue)?
2) How long does the configuration run before the issue becomes apparent?
3) What are the general configuration parameters (hdw/sftw levels, wire/wifi, etc) for one's setup?
4) How is/are the hotspot(s) used? DMR only, YSF only, mixed usage, reflectors, etc?
5) (insert any other appropriate question(s) here?)

More data is needed to support/refute the speculations.
KE7FNS
Pi-Star Team
Posts: 1944
Joined: Wed Apr 17, 2019 11:11 pm

Re: Unable to Switch Back to 'rpi-ro'

Post by KE7FNS »

KN2TOD wrote: Wed Oct 09, 2019 6:54 pm More data is needed to support/refute the speculations.
Nah, next time one of mine acts up, I'll try lsof and see if I can figure out which files are keeping things open.
If someones previous actions are any indication of their future actions, then I predict the deletion and removal of access will happen at any moment. 7-11-2020.

"07/13/20 This Website Has Been Taken Down" ... again :lol:
KN2TOD
Posts: 104
Joined: Sun Nov 11, 2018 6:36 pm

Re: Unable to Switch Back to 'rpi-ro'

Post by KN2TOD »

Great! Should be fairly soon, if my experience is any indication:

Booted all five of my hotspots together 28 hours ago. Two of them are already in permanent RW mode, apparently just in the last 8-9 hours (since I last checked).

Just a thought: could the Watchdog be set to monitor the RO/RW status and create an alert of some sort?
Post Reply