Jumbospot - can't update/downgrade firmware
Posted: Mon Sep 14, 2020 8:26 pm
I have just bought a Chinese jumbospot clone with OLED (board is not marked with type or version).
It does work, but I want to check it upgrades before leaving feedback.
In pi-star -> Expert -> SSH I use:
sudo pistar-findmodem (and it returns)
Detected MMDVM_HS (GPIO): /dev/ttyAMA0 (MMDVM_HS_Hat-v1.4.17 20190529 14.7456MHz ADF7021 FW by CA6JAU GitID #cc451c4)
When trying to update (or downgrade) with command:
sudo pistar-mmdvmhshatflash hs_hat (or sudo pistar-mmdvmhshatdowngrade hs_hat)
it downloads data from the internet, gets so far along and then returns this...
stm32flash Arduino_STM32_0.9
http://github.com/rogerclarkmelbourne/arduino_stm32
Using Parser : Raw BINARY
Interface serial_posix: 57600 8E1
Version : 0x22
Option 1 : 0x00
Option 2 : 0x00
Device ID : 0x0410 (Medium-density)
- RAM : 20KiB (512b reserved by bootloader)
- Flash : 128KiB (sector size: 4x1024)
- Option RAM : 16b
- System RAM : 2KiB
Write to memory
Erasing memory
Got NACK from device on command 0x43
Can't initiate chip erase!
Failed to erase memory
Resetting device... done.
No matter what I try, I cannot get it to upgrade or downgrade and the schematic checks out OK?!
Is it something I am doing wrong or...?
Nigel
G4ZAL
It does work, but I want to check it upgrades before leaving feedback.
In pi-star -> Expert -> SSH I use:
sudo pistar-findmodem (and it returns)
Detected MMDVM_HS (GPIO): /dev/ttyAMA0 (MMDVM_HS_Hat-v1.4.17 20190529 14.7456MHz ADF7021 FW by CA6JAU GitID #cc451c4)
When trying to update (or downgrade) with command:
sudo pistar-mmdvmhshatflash hs_hat (or sudo pistar-mmdvmhshatdowngrade hs_hat)
it downloads data from the internet, gets so far along and then returns this...
stm32flash Arduino_STM32_0.9
http://github.com/rogerclarkmelbourne/arduino_stm32
Using Parser : Raw BINARY
Interface serial_posix: 57600 8E1
Version : 0x22
Option 1 : 0x00
Option 2 : 0x00
Device ID : 0x0410 (Medium-density)
- RAM : 20KiB (512b reserved by bootloader)
- Flash : 128KiB (sector size: 4x1024)
- Option RAM : 16b
- System RAM : 2KiB
Write to memory
Erasing memory
Got NACK from device on command 0x43
Can't initiate chip erase!
Failed to erase memory
Resetting device... done.
No matter what I try, I cannot get it to upgrade or downgrade and the schematic checks out OK?!
Is it something I am doing wrong or...?
Nigel
G4ZAL