Lonestar: An issue or setup changes needed?
Posted: Sun Dec 20, 2020 8:05 pm
Hi
I have a RPi3B+ with a Chinese Jumbospot and Nextion 2.4 (USB) display. Working fairly well.
Just received a Lonestar simplex board. Replaced the Combo with the Lonestar, and set RX/TX offset to 0 (as on the box).
The setup receives the data from wifi and displays it correctly, but I have no signal on my radio, and no reaction in the display when I key my radio.
If it swap my Jumbo in again, everything works fine.
Do I need to do some setup changes, or is there a potential issue with this board?
Have rebooted, update/upgrade but still doesn't work.
br Lars
I have a RPi3B+ with a Chinese Jumbospot and Nextion 2.4 (USB) display. Working fairly well.
Just received a Lonestar simplex board. Replaced the Combo with the Lonestar, and set RX/TX offset to 0 (as on the box).
The setup receives the data from wifi and displays it correctly, but I have no signal on my radio, and no reaction in the display when I key my radio.
If it swap my Jumbo in again, everything works fine.
Do I need to do some setup changes, or is there a potential issue with this board?
Have rebooted, update/upgrade but still doesn't work.
br Lars