forum.pistar.uk

New RFinder HCP-1 works fine on 70cm and 33cm. SDR dongle shows no RF on 2M and 1.25M. I believe the HCP-1 is supposed to be quad band. Any ideas on what to look at in the config? Or, is this simply a bad unit?

Pi-Star 4.1.4
sudo pistar-findmodem
Detected MMDVM_HS (GPIO): /dev/ttyAMA0 (MMDVM_HS_Hat-v1.5.2 20201108 14.7456MHz ADF70
21 FW by CA6AU GitID #89daa20FF5606725548826687214644)

Thanks,
Joe
KF0EUQ

Your reply was appreciated.

147.700 No TX,RX
224.400 No TX,RX
448.800 OK
922.200 OK

I'll give GigaParts a call next week for an exchange.

Thanks KE7FNS,

Held a 'Team Viewer' session with Bob (CEO, Chief Architect rFinder) so he could see the issue. He has not previously observed this behavior. He will send a new HCP-1 hotspot from the next shipment he receives.