I've been trying for several days to get either of my 2 FT-3000M radios to transmit DMR and P25 as a simplex hotspot.
About the best I can do is partial, garbled decode on P25, and no audio and incorrect radio ID decodes on DMR using multiple receivers on both modes. Receive is fine, with low BER, and traffic goes out the gateways as expected.
Deviation, frequency and output power look good on the FT-3000 and I'm running the radio into a dummy load 10 feet away, so I feel like I can rule out RF getting back into the radio or pi... packet bps is 9600 on the tx radio...
Has anyone been able to get an FT-3000M running as a simplex hotpot and can shed some light on what I might be missing? I've got a couple of MMDVM repeaters built and running on UHF, so I'm not a total novice here.
Anyone running Yaesu FT-3000M with STM-32?
MMDVM_HS Hat hardware
Jump to
- Pi-Star Information
- ↳ Announcements
- ↳ Feature Requests
- ↳ FAQ
- Software Support
- ↳ Pi-Star General Support
- ↳ WiFi Setup
- ↳ IP Networking
- ↳ D-Star Specific Support
- ↳ DMR Specific Support
- ↳ YSF Specific Support
- ↳ P25 Specific Support
- ↳ NXDN Specific Support
- ↳ POCSAG Specific Support
- Hardware Support
- ↳ Raspberry Pi Foundation Hardware
- ↳ Friendly Arm Nano Pi Neo / Neo Air
- ↳ Hardkernel Odroid XU3 / XU4
- ↳ Orange Pi Zero
- ↳ Nextion Screens
- ↳ OLED Screens
- ↳ ZUMSpot (Hat / Libre / USB)
- ↳ MMDVM_HS Hat(s)
- ↳ DV-Mega Hat(s)
- ↳ DV-Mega GMSK Arduino
- ↳ DVAP Dongle
- ↳ DVR-PTR V1 V2 V3
- ↳ Other MMDVM Modem Boards
- ↳ Other All-in-one Boards with included RF
- ↳ Radio Equipment
- Repeater Keepers
- ↳ Software Support
- ↳ Hardware Support
- ↳ Everything Else
- Tutorials
- ↳ W1MSG Video Tutorials
- ↳ User Submitted Video Tutorials
- ↳ Tips and Tricks
- General Conversation
- ↳ Share your stuff
- ↳ I'm new here
- ↳ CQ CQ CQ
- ↳ I need to vent
- ↳ The Bar