STM32-DVM V3 Kenwood tm710g help

[KB1ZBT]

Greetings just trying to set up my device recently got a STM32-DVM V3 and I can't seem to get it setup right. Something is not decoding the digital so I just get digital garbled noise. Tried the tx rx settings in expert can't say I know what I'm doing just thought someone could simplify it all for me thanks
KB1ZBT

[N6MIK]

I had the same problem with my STM32 using Yaesu Radios...

Keep in mind that the tx/rx offsets in the pi-star settings don't do anything when you're connected to an external radio.... make sure that your tx deviation and frequency of the radio are good, and work the TX_G pot until you dial it in.

[KB1ZBT]

Tried this to no avail I am sure there is some simple thing I am missing like a radio setting or such. Any other advice would be welcome. Thanks

[N6MIK]

Set your radio for wideband (vs. narrow, if you have that choice), and 9600bps data. Also play with the TX Invert setting in Pi-Star's MMDVMHost settings...

[KB1ZBT]

Got it thanks

[KB1ZBT]

Really strange was working now back to no decoding tried toggling all the suggested setting but can't get it to work???