I am trying to help a new station to DMR get a MMDVM_HS_HAT_DUPLEX board set up with the correct TX deviation level using mmdvmcal, I get everything set up on the screen and am in mmdvmcal DMR deviation section (D) but am unable to toggle TX with the space bar as it should/usually does..
Is there something different that needs to be done with this breed to get it to tx.
73' Doug ZL3DMH
After Trying again today in the calibration section I tried the ptt invert setting, after that it would tx...Not sure tho if that was the problem or it just come right after a reset the next day..
All worked OK ..
MMDVM_HS_HAT_DUPLEX / mmdvmcal problem
MMDVM_HS Hat hardware
Jump to
- Pi-Star Information
- ↳ Announcements
- ↳ Feature Requests
- ↳ FAQ
- Software Support
- ↳ Pi-Star General Support
- ↳ WiFi Setup
- ↳ IP Networking
- ↳ D-Star Specific Support
- ↳ DMR Specific Support
- ↳ YSF Specific Support
- ↳ P25 Specific Support
- ↳ NXDN Specific Support
- ↳ POCSAG Specific Support
- Hardware Support
- ↳ Raspberry Pi Foundation Hardware
- ↳ Friendly Arm Nano Pi Neo / Neo Air
- ↳ Hardkernel Odroid XU3 / XU4
- ↳ Orange Pi Zero
- ↳ Nextion Screens
- ↳ OLED Screens
- ↳ ZUMSpot (Hat / Libre / USB)
- ↳ MMDVM_HS Hat(s)
- ↳ DV-Mega Hat(s)
- ↳ DV-Mega GMSK Arduino
- ↳ DVAP Dongle
- ↳ DVR-PTR V1 V2 V3
- ↳ Other MMDVM Modem Boards
- ↳ Other All-in-one Boards with included RF
- ↳ Radio Equipment
- Repeater Keepers
- ↳ Software Support
- ↳ Hardware Support
- ↳ Everything Else
- Tutorials
- ↳ W1MSG Video Tutorials
- ↳ User Submitted Video Tutorials
- ↳ Tips and Tricks
- General Conversation
- ↳ Share your stuff
- ↳ I'm new here
- ↳ CQ CQ CQ
- ↳ I need to vent
- ↳ The Bar