Both timeslots on MMDVM_HS_HAT_DUPLEX?
Posted: Wed Jul 18, 2018 4:28 pm
I have this installed:
https://www.ebay.com/itm/Duplex-MMDVM-H ... 3093603360
On a Raspberry Pi 3B+ with a 3.5" Nextion screen and am trying to figure out how to get both timeslots to work in simplex mode, using this screen: viewtopic.php?f=20&t=394
I would assume that using the dual DB9MAT config would be correct, but that one doesn't work (although it is the only one where I can see TS1 and TS2 enabled when in duplex mode). It does work in the single DB9MAT config or STM32-DVM and seems to be receiving and re-transmitting on both timeslots, although both the Pi-Star Dashboard and display show everything as TS2 with TS1 disabled. I'm running firmware 1.4.1.
On a unrelated note, I'll post the file for 3D printing a pretty cool case that a friend of mine made in SolidWorks - It combines all of the above mentioned components in a snap together/compression fit case.
https://www.ebay.com/itm/Duplex-MMDVM-H ... 3093603360
On a Raspberry Pi 3B+ with a 3.5" Nextion screen and am trying to figure out how to get both timeslots to work in simplex mode, using this screen: viewtopic.php?f=20&t=394
I would assume that using the dual DB9MAT config would be correct, but that one doesn't work (although it is the only one where I can see TS1 and TS2 enabled when in duplex mode). It does work in the single DB9MAT config or STM32-DVM and seems to be receiving and re-transmitting on both timeslots, although both the Pi-Star Dashboard and display show everything as TS2 with TS1 disabled. I'm running firmware 1.4.1.
On a unrelated note, I'll post the file for 3D printing a pretty cool case that a friend of mine made in SolidWorks - It combines all of the above mentioned components in a snap together/compression fit case.