Help with NXDN issues
7 posts • Page 1 of 1
Is there any way to enable pi-star remote commands from NXDN? Specifically I'd like to be able to shutdown the hotspot from my NXDN radio, but I don't see a block of NXDN commands in the pi-star remote editor. Is it possible to add those?
You might want to add support for P25 as well..MW0MWZ wrote:I could add the remote commands for NXDN, BUT, there are 65535 IDs on NXDN, its not enough to be able to dedicate some just for use as remote commands, this is why I never added it.
Sent from my Pixel 2 XL using Tapatalk
P25 is in there
Code: Select all
[banner] # Pi-Star Remote config file # This config file is desiged for the Pi-Star Keeper remote control # The remote control system is designed to give repeater keepers an # RF KillSwitch for their repeaters. [enable] # Is the Pi-Star Remote Enabled? (true|false) enabled=false [keeper] # Keepers Information callsign=M1ABC [d-star] # UR fields svckill=SVCKILL svcrestart=SVCRSTRT reboot=REBOOTPI #shutdown=SHUTDOWN #8Ball=8BALL [dmr] # TG commands svckill=9999999 svcrestart=9999998 reboot=9999997 #shutdown=9999996 [ysf] # ROOM commands svckill=99999 svcrestart=99998 reboot=99997 #shutdown=99996 [p25] # P25 Talkgroups are limited to 1->65535 svckill=65531 svcrestart=65532 reboot=65533 #shutdown=65534
73 de MW0MWZ
73 de MW0MWZ
It would not matter, there is no id routing in NXDN like there is in DMR & any number used for remote nominated will not effect an owner of that id.
Only reflector and NXCore TG's are used on NDXN in any case. So if you nominate 33333, 44444, 55555 for that control and someones callsign is assigned to same on uid.csv/NXDN.csv, it wont matter, there are no bad effects. I think you are confused with DMR.