Our 70cm repeater currently working on DSTAR, C4FM & DMR using v3 STM32 pi-hat board from Repeater Builder in the USA and pi-star v3.4.17
We want to add NXDN and it was working when I tested it a short while ago, now when I enable it I see TX & RX ok on the dashboard but the repeater does not activate.
Live log reports,
NXDN, overflow in the NXDN RF queue
Tried a few different setting in the modem section, ie RX level & TX level but all modes work fine except NXDN.
Any help appreciated.
Mike g1ZRN.
NXDN stopped working........
Re: NXDN stopped working........
I had to do a firmware update on my stm32 board.....Once I did that...all worked
Steve
Steve
Re: NXDN stopped working........
Just managed to do a firmware update remotely and now it's working, but one minor problem, it seems to get "stuck" in NXDN mode even though the dashboard reports that the repeater is idle.
Mike.
Mike.
Re: NXDN stopped working........
I purchased another STM32 v3a board from Repeater builder so I can test at home before doing any changes to our repeater.
I updated the firmware and altered the idle times, pleased to report all seems to be working 99% of the time with the odd occasion where it gets "stuck" in NXDN mode despite the dashboards and my Nextion screen showing idle.
Mike G1ZRN
I updated the firmware and altered the idle times, pleased to report all seems to be working 99% of the time with the odd occasion where it gets "stuck" in NXDN mode despite the dashboards and my Nextion screen showing idle.
Mike G1ZRN