STM32 repeater builder pi-hat RSSI setup

Help with other MMDVM Repeater Boards (with NO onboard RF)
Post Reply
g7kbr
Posts: 70
Joined: Thu Nov 01, 2018 1:03 pm

STM32 repeater builder pi-hat RSSI setup

Post by g7kbr »

Hi all

I have a STM32 repeater builder pi-hat board on my MMDVM repeater.

I would like to setup the RSSI, but need to know how to setup the RSSI pot. If I go into MMDVMCal and run the RSSI test. I can see the figures and if I adjust the POT this figure changes.

I have my radio test setup on RX and can adjust the RX level and see change.

Can anyone help, is their a voltage I need to setup?

My radios are GM350’s and I have a feed for RSSI on pin 15.

I did look on the repeater builder website but could see any setup information. I have the version 3 board.

Regards

Paul
G7KBR


Sent from my iPhone using Tapatalk
Post Reply