forum.pistar.uk

Hi,

Im using the RPT HAT from Flo DF2FT
My firmware is the "20180723"
Now i would like to make the board ready for DAPNET. So i need to switch the TX Frequenz automatically of the GM360.
Is there a new firmware with the support for this?
On the board there is a pin called CHSW. (Channel Switch)??

regards Chris

Afaia you'll need to recompile the MMDVM host software and replace the vers. that's currently in situ and then manually configure the .ini for it's use.

I don't believe it's added with the default pistar install.

You'll then obvs. Have to enable the alt. freq.(channel) setting in the gm360 setup.

Sent from my SM-G935F using Tapatalk