Hi All,
I have been successfully using my PI-Star hotspot for the last month or so with my Icom IC-7100 ( PI-Star Ver : 4.1.0-RC4)
When I tried to do a QSO yesterday on REF 001 C, I was getting no reply and as you can see from the first picture a beep and the below message : "RPT? : EI2IXB B (HOTSPOT)"
I have went through my settings on the Hotspot in fine detail and nothing has changed and borrowed a DV Mega and configured it and used Blue DV and Volia it works.
I've made no changes to my hotspot and it is using the same configuration from the day I set it up.
I did notice however on my Icom IC-7100 in the Callsign menu R2 : is saying not used* and should be saying EI2IXB G, but it does not let me change it.
I am baffled on what is wrong and have tried everything I could think of right down to rebuilding the hotspot with a new image to no avail.
Can RX but no longer TX on D-Star
Can RX but no longer TX on D-Star
- Attachments
-
- Pic 3.png (157.15 KiB) Viewed 2320 times
-
- Pic 2.png (124.47 KiB) Viewed 2320 times
-
- Pic 1.png (154.21 KiB) Viewed 2320 times
Re: Can RX but no longer TX on D-Star
And pictures of the 7100
- Attachments
-
- 2019-11-10 15.21.33-min(1).jpg (169.69 KiB) Viewed 2319 times
-
- 2019-11-10 15.23.26-min.jpg (157.49 KiB) Viewed 2319 times
-
- 2019-11-10 15.23.11-min.jpg (187.25 KiB) Viewed 2319 times
Re: Can RX but no longer TX on D-Star
Unfortunately the PDF manual leaves a lot to be desired -- your "Use Repeater" screen was not seen in the manual while I was flipping through the D-STAR section.
I suspect you need to be set for the equivalent of "Use Gateway".
I suspect you need to be set for the equivalent of "Use Gateway".
--
AF6VN
Dennis L Bieber