Page 1 of 1
2 dvrptr boards at once
Posted: Tue Jun 11, 2019 8:54 pm
by VE3MJM
Hi All
Can we run 2 dvrptr v1 boards on one pi with pistar at the same time; one on vhf and one uhf( module B and C)?
Thanks
Don
Re: 2 dvrptr boards at once
Posted: Tue Jun 11, 2019 11:52 pm
by VK7HSE
No, mmdvm was not designed to be as a multi host system. So it's single device only.
Sent from my Pixel 2 XL using Tapatalk
Re: 2 dvrptr boards at once
Posted: Wed Jun 12, 2019 1:59 pm
by VE3MJM
Thanks for the reply.
No sure we explained this.
The question is, Can Pi-Star support 2 DVRPTR BOARDS at once. Want to run two simplex DSTAR(only) nodes. One on V and the other on U.
If you do "CONFIG" "EXPERT' "DSTARREPEATER" ; there are multiple settings for DVRTPR one and two and three.
eg
dvrptr1Port=
dvrptr2Port=
dvrptr3Port=
We only want to run DSTAR, and that is all you can run when you configure PISTAR to a "Dstarrepeater" and not to "MMDVMHost"
VK7HSE, do you have or have you used a DVRPTR board? A DVRPTR V1 board is not multi mode board, as far as I know. I could be wrong.
If you are correct, why would there be setting for 3 DVRPTR boards?
73
Don