No Rooms or ability to change them..

Help with YSF / Fusion issues
Post Reply
VA7WPN
Posts: 20
Joined: Sun May 13, 2018 3:51 am

No Rooms or ability to change them..

Post by VA7WPN » Mon May 21, 2018 6:41 am

Using an FTM-400 and a FT2, I have not been able to pull a room list, or change the rooms via either radio.

Is this something inherent in the Pi-Star Image/MMDVM ? Or perhaps I have not setup the YSF (There is really nothing to setup) on PiStar software?

thanks again for your help!

User avatar
MW0MWZ
Site Admin
Posts: 1075
Joined: Wed Apr 04, 2018 9:15 pm
Location: Wales, UK
Contact:

Re: No Rooms or ability to change them..

Post by MW0MWZ » Mon May 21, 2018 7:36 pm

First make sure your Pi-Star is right up to date, and that you have visited the config page and applied it (even if nothing changed) after the update.

You should be on 3.4.13 at this point.

Next up, FCS is quite fussy about frequency, if its not close to perfect, it will not behave well, if you are using multi-mode, try turning the other modes off and just using YSF until you have it working right.

Hope that helps.
Andy

73 de MW0MWZ
http://pistar.uk

Post Reply