Ysf-p25 no rx
Posted: Sat Oct 05, 2019 1:54 pm
Ok so I have my yaesu ft2d in VW mode for the ysf-p25 crossmode.
I have ysf and ysf-p25 enabled and saved changes.
I then go into the yaesu fusion configuration on pi star and select ysf 00004 ysf-p25 as the main room or server if you like then I select a talkgroup or even the parrot sometimes,
However,
This is where the problem starts....
As soon as I key with this current configuration I can be heard on reflectors and I can see a carrier on radio but I am not receiving any audio back, just a dead carrier!. Operators have sent me messages saying I’m on the network and been heard.
Is this my configuration, is this a port forwarded issue?
I cannot understand what is wrong as this was working.
I am using pistar 4.1 RC6 on a jumbospot using WiFi,
Any advice would be greatly appreciated
Thankyou
Chris
2E0EEY
I have ysf and ysf-p25 enabled and saved changes.
I then go into the yaesu fusion configuration on pi star and select ysf 00004 ysf-p25 as the main room or server if you like then I select a talkgroup or even the parrot sometimes,
However,
This is where the problem starts....
As soon as I key with this current configuration I can be heard on reflectors and I can see a carrier on radio but I am not receiving any audio back, just a dead carrier!. Operators have sent me messages saying I’m on the network and been heard.
Is this my configuration, is this a port forwarded issue?
I cannot understand what is wrong as this was working.
I am using pistar 4.1 RC6 on a jumbospot using WiFi,
Any advice would be greatly appreciated
Thankyou
Chris
2E0EEY