Page 1 of 1

Ysf-p25 no rx

Posted: Sat Oct 05, 2019 1:54 pm
by 2e0eey
Ok so I have my yaesu ft2d in VW mode for the ysf-p25 crossmode.

I have ysf and ysf-p25 enabled and saved changes.

I then go into the yaesu fusion configuration on pi star and select ysf 00004 ysf-p25 as the main room or server if you like then I select a talkgroup or even the parrot sometimes,


This is where the problem starts....
As soon as I key with this current configuration I can be heard on reflectors and I can see a carrier on radio but I am not receiving any audio back, just a dead carrier!. Operators have sent me messages saying I’m on the network and been heard.

Is this my configuration, is this a port forwarded issue?

I cannot understand what is wrong as this was working.

I am using pistar 4.1 RC6 on a jumbospot using WiFi,

Any advice would be greatly appreciated