Sorry if I've missed the obvious, but, I've been looking into using the displayport on the pi with my monitor, or an hdmi one and I happened upon this thread. Is there a complete tutorial or list of steps to make this happen? I'm seeing bits of commands here and there and I'm not sure where to start.
I did a search on this board for the subject and didn't get any hits.
thanks
tim
[Solved] Can PiStar GUI by installed on the RPi 3B+
General support for the Pi-Star System
Return to “Pi-Star General Support”
Jump to
- Pi-Star Information
- ↳ Announcements
- ↳ Feature Requests
- ↳ FAQ
- Software Support
- ↳ Pi-Star General Support
- ↳ WiFi Setup
- ↳ IP Networking
- ↳ D-Star Specific Support
- ↳ DMR Specific Support
- ↳ YSF Specific Support
- ↳ P25 Specific Support
- ↳ NXDN Specific Support
- ↳ POCSAG Specific Support
- Hardware Support
- ↳ Raspberry Pi Foundation Hardware
- ↳ Friendly Arm Nano Pi Neo / Neo Air
- ↳ Hardkernel Odroid XU3 / XU4
- ↳ Orange Pi Zero
- ↳ Nextion Screens
- ↳ OLED Screens
- ↳ ZUMSpot (Hat / Libre / USB)
- ↳ MMDVM_HS Hat(s)
- ↳ DV-Mega Hat(s)
- ↳ DV-Mega GMSK Arduino
- ↳ DVAP Dongle
- ↳ DVR-PTR V1 V2 V3
- ↳ Other MMDVM Modem Boards
- ↳ Other All-in-one Boards with included RF
- ↳ Radio Equipment
- Repeater Keepers
- ↳ Software Support
- ↳ Hardware Support
- ↳ Everything Else
- Tutorials
- ↳ W1MSG Video Tutorials
- ↳ User Submitted Video Tutorials
- ↳ Tips and Tricks
- General Conversation
- ↳ Share your stuff
- ↳ I'm new here
- ↳ CQ CQ CQ
- ↳ I need to vent
- ↳ The Bar