It worked before the last update to 4.1.0.rc8. at least for me. Now on 4.1.0(RC8) they jump back to C value on the nextion display. It briefly shows F value when it starts up.
In addition on my two 3A+ hotspots (with 3.2 nextion via usb-ttl) they are locking up? At present I am testing via another 3A+ one piece at a time. ran the pi 3A+ with no hat and no screen over night and it did not lock up. today it will run with mmdvm hat (no screen) and see how that goes for a day or two. I run a usb voltage tester and checked the via "dmesg | grep -i volt" and see no voltage problems (yet) on the 3A's but did through other checking see an issue on my 3B+ that has a 7 inch "P" screen (another issue I will have to work on). Neither of the 3A's locked up when I was using 4.0.0 and they run about 7+ degrees cooler on 4.0.0 vs 4.1.0. I know the limits are much higher but I wonder if running around 57 C might be an issue so I am doing more tests for that
change temp fro celcious to fahrenheit
All things relating to the Nextion Screen(s)
Jump to
- Pi-Star Information
- ↳ Announcements
- ↳ Feature Requests
- ↳ FAQ
- Software Support
- ↳ Pi-Star General Support
- ↳ WiFi Setup
- ↳ IP Networking
- ↳ D-Star Specific Support
- ↳ DMR Specific Support
- ↳ YSF Specific Support
- ↳ P25 Specific Support
- ↳ NXDN Specific Support
- ↳ POCSAG Specific Support
- Hardware Support
- ↳ Raspberry Pi Foundation Hardware
- ↳ Friendly Arm Nano Pi Neo / Neo Air
- ↳ Hardkernel Odroid XU3 / XU4
- ↳ Orange Pi Zero
- ↳ Nextion Screens
- ↳ OLED Screens
- ↳ ZUMSpot (Hat / Libre / USB)
- ↳ MMDVM_HS Hat(s)
- ↳ DV-Mega Hat(s)
- ↳ DV-Mega GMSK Arduino
- ↳ DVAP Dongle
- ↳ DVR-PTR V1 V2 V3
- ↳ Other MMDVM Modem Boards
- ↳ Other All-in-one Boards with included RF
- ↳ Radio Equipment
- Repeater Keepers
- ↳ Software Support
- ↳ Hardware Support
- ↳ Everything Else
- Tutorials
- ↳ W1MSG Video Tutorials
- ↳ User Submitted Video Tutorials
- ↳ Tips and Tricks
- General Conversation
- ↳ Share your stuff
- ↳ I'm new here
- ↳ CQ CQ CQ
- ↳ I need to vent
- ↳ The Bar