Please update to the latest YSFGateway code so we can support the FT3 GPS and add Wires-X passthrough for XLX. I have compiled the latest code from github and replaced the included binary without any issues.
73,
Scott KB2EAR
Update to latest YSFGateway code
Re: Update to latest YSFGateway code
@KB2EAR, thanks for calling my attention to this. I installed the updated G4KLX code for YSFGateway today on my RC8 system and it works wonderfully. I am now able to switch modules on my XLX.
Tom, please give consideration to incorporating this at the earliest possibility.
73,
Dan K2IE
Tom, please give consideration to incorporating this at the earliest possibility.
73,
Dan K2IE
Re: Update to latest YSFGateway code
Tom. ??k2dls wrote:
Tom, please give consideration to incorporating this at the earliest possibility.
73,
Dan K2IE
There's a possible issue found in the new YSFgateway release, so currently work in progress.
Sent from my SM-G935F using Tapatalk
Andrew M1DNS.
Pi-star Admin Team.
Pi-star Admin Team.
Re: Update to latest YSFGateway code
Ha-
I know of someone named Tom Taylor, so I suppose my brain is scrambled from too much social distancing! Apologies to Andy, Tom or whoever is behind that curtain.
73
I know of someone named Tom Taylor, so I suppose my brain is scrambled from too much social distancing! Apologies to Andy, Tom or whoever is behind that curtain.
73
Re: Update to latest YSFGateway code
Pulled built and punted into the update system... but...
It mostly works, but the passthrough code still needs some work. I'll see if we can come up with a work-around for that.
It mostly works, but the passthrough code still needs some work. I'll see if we can come up with a work-around for that.
Re: Update to latest YSFGateway code
What kind of issues are you seeing? I have been testing for a few days and all works as expected.
Re: Update to latest YSFGateway code
Thanks very much Andy.
73
73
Re: Update to latest YSFGateway code
When you connect to an XLX, you then have to turn off Wires-X mode and turn it back on again to be able to control where you are linked on the XLX.
With the rest of the pass-through systems that is not the case, this is due to the way WiresX commands (and the replies) are targeted.
Re: Update to latest YSFGateway code
I thought that was normal, as I have had to back out and come back in to YSF2NXDN and YSF2P25 for as long as I can remember. But in playing with it today I see that I can get a room list from YSF2NXDN but it takes 2 tries to connect to a room. And the same on YSF2P25. I think that may be because of the voice announcement killing the ack.
But anyway, at least is usable as it sits now.
Thanks for all of your efforts & 73,
Scott KB2EAR
But anyway, at least is usable as it sits now.
Thanks for all of your efforts & 73,
Scott KB2EAR