Think this is the most relevant thread for the issue I'm having...so here goes...please advise if there's a more relevant one however:
Recently enabled YSF on my PiStar repeater (repeater not hotspot).
When I press the WiresX button nothing happens, however if I give the PTT a longer press (2secs) the repeater wakes and then the WiresX button functionality will return the room info and allow me to change rooms etc...seems like a timeout issue but it's strange that in idle the WiresX button has no effect until a longer PTT to wake??
Any ideas? Anyone come across this before and know a workaround?
My setup is a PiStar running on a 3b+ connected to a Yaesu DR1X repeater.
DStar works perfectly.
DMR works perfectly.
Thanks,
Rob.
Long PTT for YSF
Re: Long PTT for YSF
Yep, that's the way you need run it. When idle the data burst from a X command is often to short to wake the install. Keying up before hand allows the modem to grab and 'lock' to the mode.
Sent from my SM-G935F using Tapatalk
Sent from my SM-G935F using Tapatalk
Andrew M1DNS.
Pi-star Admin Team.
Pi-star Admin Team.
Re: Long PTT for YSF
Ah ok - thanks - nothing the I could tweak in the settings?
If not I’ll put a note on the repeater website about it.
73.
If not I’ll put a note on the repeater website about it.
73.
Re: Long PTT for YSF
On my FT3D I tap the X button a second time for the hotspot, same with the '400.
73 de John K2CQW
Re: Long PTT for YSF
Yep. One def. help would be to turn off all the other modes.M0ORA wrote: nothing the I could tweak in the settings?
If not I’ll put a note on the repeater website about it.
73.
Sent from my SM-G935F using Tapatalk
Andrew M1DNS.
Pi-star Admin Team.
Pi-star Admin Team.
Re: Long PTT for YSF
Haha...that’s not happening
Out of interest is this the same across the entire WiresX capable range or just certain models that have this issue?
Out of interest is this the same across the entire WiresX capable range or just certain models that have this issue?
Re: Long PTT for YSF
In my case I only have YSF enabled though I also have YSF2DMR configured. I have to push the Wires-X button 2 times to wake it up. This is with an FT3. I don't remember my FT2 doing this with PI-Star v3.
Re: Long PTT for YSF
Try adjusting rx offset slightly to improve BER aiding the install to better recognise you. But as said the initial Xbutton burst is a very short tx.
Sent from my SM-G935F using Tapatalk
Sent from my SM-G935F using Tapatalk
Andrew M1DNS.
Pi-star Admin Team.
Pi-star Admin Team.