Hi all
I have a STM32 repeater builder pi-hat board on my MMDVM repeater.
I would like to setup the RSSI, but need to know how to setup the RSSI pot. If I go into MMDVMCal and run the RSSI test. I can see the figures and if I adjust the POT this figure changes.
I have my radio test setup on RX and can adjust the RX level and see change.
Can anyone help, is their a voltage I need to setup?
My radios are GM350’s and I have a feed for RSSI on pin 15.
I did look on the repeater builder website but could see any setup information. I have the version 3 board.
Regards
Paul
G7KBR
Sent from my iPhone using Tapatalk
STM32 repeater builder pi-hat RSSI setup
Help with other MMDVM Repeater Boards (with NO onboard RF)
Return to “Other MMDVM Modem Boards”
Jump to
- Pi-Star Information
- ↳ Announcements
- ↳ Feature Requests
- ↳ FAQ
- Software Support
- ↳ Pi-Star General Support
- ↳ WiFi Setup
- ↳ IP Networking
- ↳ D-Star Specific Support
- ↳ DMR Specific Support
- ↳ YSF Specific Support
- ↳ P25 Specific Support
- ↳ NXDN Specific Support
- ↳ POCSAG Specific Support
- Hardware Support
- ↳ Raspberry Pi Foundation Hardware
- ↳ Friendly Arm Nano Pi Neo / Neo Air
- ↳ Hardkernel Odroid XU3 / XU4
- ↳ Orange Pi Zero
- ↳ Nextion Screens
- ↳ OLED Screens
- ↳ ZUMSpot (Hat / Libre / USB)
- ↳ MMDVM_HS Hat(s)
- ↳ DV-Mega Hat(s)
- ↳ DV-Mega GMSK Arduino
- ↳ DVAP Dongle
- ↳ DVR-PTR V1 V2 V3
- ↳ Other MMDVM Modem Boards
- ↳ Other All-in-one Boards with included RF
- ↳ Radio Equipment
- Repeater Keepers
- ↳ Software Support
- ↳ Hardware Support
- ↳ Everything Else
- Tutorials
- ↳ W1MSG Video Tutorials
- ↳ User Submitted Video Tutorials
- ↳ Tips and Tricks
- General Conversation
- ↳ Share your stuff
- ↳ I'm new here
- ↳ CQ CQ CQ
- ↳ I need to vent
- ↳ The Bar