DV-Mega Single / Dual band Hat for the Raspberry Pi
7 posts • Page 1 of 1
I'm setting up a dv-mega running pi-star and a kenwood D74 radio. Pi-star seems to be up and running. Radio seems to be programmed correctly. I know the mega is hearing the radio but no reception, no transmit out to the internet even though on the pi-star config page wifi is up and running. On the admin page it says link down. The radio tells me I am connected to the reflector, but on the bottom right of the D74 I get a red X when I transmit. Seems something is preventing the tx and rx from coming through the mega. I have tryed many different configs in both the radio and pi-star. I programmed the radio using the kenwood mcp d74 software. Have the off set in, 0.000- and rpt1 rpt2 setup with C and G in the eighth spot. Help/WF2ZMatt
Last edited by wf2z on Fri Aug 03, 2018 12:35 pm, edited 1 time in total.
That red x could indicate an issue with your D-STAR registration. Is it possible you registered twice? You might need to contact
Take a look here: https://wb1gof.dstargateway.org/cgi-bin ... lsign=wf2z
Your terminals in USTRUST users.txt are fine ;
[WF2Z ] [WA4TCD C]
[WF2Z D] [KC2TGB A]
Add your hotspot to the kenwood repeater list using 0 offset, with same tx/rx freq.
Then use DR mode and select your own system in repeater list to satisfy the RPR1/RPT2 MMDVMHost rpt validation requirement.